User manual WHIRLPOOL ADG 9511 A PRODUCT FICHE

[. . . ] • Check with a qualified electrician or service representative if you are in doubt whether the appliance is properly grounded. Do not modify the plug provided with the appliance; If it does not fit the outlet. Have a proper outlet installed by a qualified electrician. WARNING: PROPER USE • Do not abuse, sit on, or stand on the door or dishrack of the dishwasher. • Do not operate your dishwasher unless all enclosure panels are properly in place. [. . . ] If you buy new dishes please make sure that they are suitable for dishwashers. NOTE: Please do not overload your dishwasher. There is only space for 9 standard dishes. Do not use dish that is not suitable for dishwashers. This is important for good results and for reasonable energy consume. Loading cutlery and dishes Before loading the dishes, you should: Remove large leftover Soften remnants of burnt food in pans When loading the dishes and cutlery, please note: Dishes and cutlery must not impede the rotation of the spray arms. Load hollow items such as cups, glasses, pans etc. with the opening downwards so that water cannot collect in the container or a deep base. WARNING: It is dangerous to open the door when washing, because the hot water may be scalded to you. The door should not be left in the open position since this could present a tripping hazard. 45 STARTING A WASHING PROGRAMME Wash Cycle Table NOTE Meaning: need to fill rinse into the Rinse-Aid Dispenser. • • * En50242: This program is the test cycle, the rinse-aid dispenser setting is recommended to be set to position 6. • The power consumption of off-mode is 0W, left-on model is 0. 73W. Cycle selection information For heaviest soiled crockery, and normally soiled pots pans dishes etc with dried on soiling. After the spray arms stop working, you can open the door completely. Close the door, the dishwasher will start running again after 10 seconds. At the End of the Wash Cycle When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher. Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. • Switch Off the Dishwasher The program has ended, only if there appears a 0 in the digital display (remaining program time). Switch off the dishwasher by pressing the ON/OFF button. The dishes should therefore be allowed to cool down around 15 minutes before removing from the appliance. Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they will be cooler and the drying will be improved. • Unloading the dishwasher It is normal that the dishwasher is wet inside. [. . . ] site installation or the If in doubt, contact a suitably qualified plumber. cross-section of the piping. Unsatisfactory washing result Problem Possible causes What to do See notes in "Loading the Dishwasher Baskets". See "Wash Cycle Table" The dishes are not The dishes were not clean loaded correctly. The programme was not powerful enough. Not enough detergent was Use more detergent, or change your detergent. [. . . ]