User manual WHIRLPOOL ADG 9624 WH PRODUCT FICHE

[. . . ] Inlet hose marked ”25°C Max”: maximum temperature 25°C. All other models: maximum temperature 60°C. • When installing the appliance, make sure the drain water discharges correctly (if necessary, remove the wire gauze from the sink siphon). • Fix the drain hose to the spigot with a clamp to prevent it from coming off during operation. [. . . ] • Store the detergent, rinse aid and salt in a dry place out of the reach of children. General recommendations: • The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it: the appliance may topple over!• Do not use solvents inside the dishwasher: risk of explosion!• Only use detergents, rinse aids and regeneration salts specially recommended for use in domestic dishwashers. • Before cleaning or carrying out maintenance, switch off the appliance, disconnect the mains plug and turn off the water tap. • If a fault occurs, switch off the appliance and turn off the water tap. • If necessary, the power cable may be replaced with another of the same kind obtained from our AfterSales Service. The power cable must only be replaced by a qualified technician. • On completion of the programme switch off the dishwasher and turn off the water tap. For appliances with water stop system, this operation is not necessary. Before using the dishwasher for the first time, fill the rinse aid dispenser. Only use rinse aids recommended for use in domestic dishwashers. Fill the dispenser with rinse aid until the dispenser level indicator becomes dark. If any rinse aid is spilled, it must be removed immediately!This prevents the formation of excessive amounts of foam, which might result in poor washing results. Close the cover. How to adjust the rinse aid dosage regulator Factory setting: position 4. If you are not satisfied with washing or drying results, change the rinse aid dosage setting. Thereafter, regularly check the rinse aid level. If crockery is prone to whitish streaks: reduce the dosage by turning the dial to a lower setting (-) using a coin or the like. If crockery is not perfectly dry: increase the dosage by turning the dial to a higher setting (+). Rinse aid level indicator: Visual indicator: light dark add rinse aid sufficient rinse aid Additional electric indicator (if provided): The indicator lamp on the control panel lights up when more rinse aid needs to be added. 71 3GB94501. fm5 Page 72 Monday, July 9, 2001 5:01 PM HOW TO FILL THE DETERGENT DISPENSER A special compartment is provided for the detergent. [. . . ] Remount the spray arm by aligning it with the rotary mounting. Tighten the fixing nut by turning it clockwise. The fixing nut must be tightened until it clicks!Make sure the spray arm rotates freely. Lower spray arm: 1. [. . . ]