User manual WHIRLPOOL ADG78002

[. . . ] Quick reference guide Chart BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED. (see at right for options description) PROGRAM SELECTION BUTTON Push “P” button (repeatedly) until selected program number is shown on the display (P1. . . Px) - see “Table of programs” below. START/RESUME BUTTON Push this button to start the selected program: the indicator lights up and goes off at the end of the program. [. . . ] Check if the dishwasher’s door is closed. Check whether the “Delayed start” option (if available) has been selected. If it has, the appliance will only start once the set time has elapsed. If necessary, RESET the appliance by pressing CANCEL or start the cycle immediately by pressing START. The water inlet hose must not be kinked and the relative inlet filter in the water tap connector must not be clogged. The water tap must be fully open during water inlet (minimum capacity: 0. 5 litres per minute). The water inlet hose must not be kinked and the relative inlet filter in the water tap connector must not be dirty. The filters must not be dirty or clogged. bowls, cups) must be arranged facing downwards in the rack. The drain hose must be fitted correctly (for high mounted appliances, leave min. 200-400 mm from the lower edge of the appliance) - see Assembly instructions. Repeat without detergent or wait until foam disappears. The closure disk of the syphon hose connection must be removed. Error number “E”y - blinking Solutions. . . Check the household circuit fuse if there is no power supply. 0. 5 sec. pause . . . shows “F6 . . . shows “F6 E2” E7” or “F6 E1” - . . . shows “F6 E3”/wash program ended too early (dishes are dirty and wet) - . . . shows “F8 E1” - After taking the above course of action, the fault message must be reset. In the majority of cases the fault is thus eliminated. Water drains automatically for up to 1 minute. The appliance is now ready to be restarted. Possible causes. . . Too little space between dishes (incorrect arrangement of the concave items in the rack). T little detergent; detergent too old or incorrectly stored. oo T emperature not high enough for heavily soiled crockery. Loading of the dishwasher using lower and upper rack at the same time with “Half load/Multizone” option. Clogged spray arms, dirty filters or not fitted correctly. [. . . ] knives), must be placed in the cutlery basket with the sharp end facing downwards. Long-handled utensils must be arranged horizontally in the upper rack, with the sharp end facing away from the front of the appliance. The guarantee is not applicable if faults are caused by incorrect use of the appliance. - Before cleaning or carrying out maintenance, disconnect the mains plug and turn off the water tap; also in the event of any malfunction. [. . . ]