User manual WHIRLPOOL ADG8783 A PCTR 6S FD INSTRUCTION FOR USE

[. . . ] Quick reference guide Chart BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED. WASH TIME DISPLAY Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates the time remaining until program start (h. 00) - below 1h (0:min). [. . . ] - The water inlet hose must not be kinked and the relative inlet filter in the water tap connector must not be clogged. - The water tap must be fully open during water inlet (minimum capacity: 0. 5 litres per minute). - The water inlet hose must not be kinked and the relative inlet filter in the water tap connector must not be dirty. - The filters must not be dirty or clogged. bowls, cups) must be arranged facing downwards in the rack. - The drain hose must be fitted correctly (for high mounted appliances, leave min. 200-400 mm from the lower edge of the appliance) - see Assembly instructions. - Repeat without detergent or wait until foam disappears. - The closure disk of the syphon hose connection must be removed. . . . shows “F6 E2” - Water tap closed. - Kinked water inlet hose or clogged inlet filters. . . . shows “F6 E7” or “F6 E1” - Water pressure too low. - Kinked water inlet hose or clogged inlet filters. . . . shows “F6 E3”/wash program ended too - Dirty or clogged filters. early (dishes are dirty and wet) - Too little water in the dishwasher’s water system. . . . shows “F8 E1” - Dirty filters. - Syphon hose connection closed. After taking the above course of action, the fault message must be reset. In the majority of cases the fault is thus eliminated. Water drains automatically for up to 1 minute. The appliance is now ready to be restarted. GB -9- What to do if. . . Crockery and cutlery. . . . . . are not perfectly clean/have food residues Possible causes. . . Solutions. . . - T little space between dishes (incorrect oo - Arrange crockery so that items do not touch each other. arrangement of the concave items in the rack). bowls, cups) must be arranged facing downwards in the rack. - Too little detergent; detergent too old or incorrectly stored. - Temperature not high enough for heavily soiled crockery. [. . . ] - Sharp items that might cause injury (e. g. knives), must be placed in the cutlery basket with the sharp end facing downwards. Long-handled utensils must be arranged horizontally in the upper rack, with the sharp end facing away from the front of the appliance. The guarantee is not applicable if faults are caused by incorrect use of the appliance. [. . . ]