User manual WHIRLPOOL ADL 350 WH PRODUCT FICHE

[. . . ] • • This appliance is designed for use in the home in compliance with its intended purpose. All water and electrical connections must be carried out by a qualified technician in compliance with the manufacturer's instructions (refer to the enclosed installation booklet) and current local safety regulations. • PROTECTING THE ENVIRONMENT 1. Packing The packing box may be fully recycled as confirmed by the recycling symbol . Appliance The appliance is built from reusable materials. [. . . ] Replace the cap. A How to adjust the rinse aid dosage regulator. (Open the cover and close again following adjustment). Factory setting: 3 If you are not satisfied with washing or drying results, change the dial setting with a spoon handle or coin. If crockery is prone to whitish streaks, reduce the dosage by turning the dial to a lower setting. If instead crockery is wet, increase the dosage by turning the dial to a higher setting. Rinse aid level indicator (visual or electric indicator depending on the model installed). Electric indicator: The indicator lamp on the control panel illuminates when the rinse aid dispenser is empty. Visual indicator: light= empty; dark= full. 15 HOW TO FILL THE DETERGENT DISPENSER Only use detergents recommended for use in domestic dishwashers. If you use “new generation” enzyme-based detergents, select the Bio programmes which are also suitable for all normal detergents. If you use detergents in pellet form, follow the manufacturer's directions for use. Always use the recommended dosage stated on the detergent pack. The use of detergent in excess of the recommended dosage may cause pollution. The recommended dosage varies between different brands. The figures inside the large compartment serve as a dosage guide. Select a new programme using the programme selector knob and press the Start button. The End indicator lamp (if fitted) illuminates briefly and the Start indicator lamp switches off to indicate the end of the programme. 3 4. Turn the programme selector knob counter clockwise to the “0” position to switch off the dishwasher (only after the End indicator lamp has illuminated briefly or the Start indicator lamp has switched off). Note: If the dishwasher is switched off during a wash programme, when switched on again the dishwasher resumes the wash cycle from where it was interrupted. Open the door and unload first the lower rack and then the upper one. 4 17 CONNECTIONS Refer to the separate installation instructions booklet. Water inlet and drain: • Strictly follow local Water Board regulations. • Make sure the inlet and drain hoses are kinkfree and are not crushed. • If the hose length does not suffice, replace with similar hoses obtained from your local dealer or our After-Sales Service. • The inlet hose must be securely clamped to the water tap to prevent leaks. • The inlet water temperature varies according to the model installed: inlet hose marked “25°C max. ”: maximum temperature 25°C All other models: maximum temperature 60°C. • When installing the appliance, make sure the drain water discharges correctly and, if necessary, remove the wire gauze from the sink siphon. [. . . ] 3 pin, 13 amp plug conforming to BS 1363A) a. The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the letter “E” or by the Earth symbol or coloured yellow or green and yellow. The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured black. The BROWN wire must be connected to the terminal which is marked with the letter “L” or coloured red. [. . . ]