User manual WHIRLPOOL ADL 357/S INSTRUCTION FOR USE

[. . . ] GB SUMMARY PAGE BEFORE USING THE DISHWASHER PROTECTING THE ENVIRONMENT PRECAUTIONS AND GENERAL RECOMMENDATIONS ENERGY AND WATER SAVING TIPS HOW TO FILL THE SALT CONTAINER HOW TO FILL THE RINSE AID DISPENSER HOW TO FILL THE DETERGENT DISPENSER HOW TO USE THE DISHWASHER CONNECTIONS MAINTENANCE AND CLEANING TROUBLESHOOTING GUIDE AFTER-SALES SERVICE 13 13 13 13 14 15 16 17 18 20 21 21 PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE For maximum satisfaction from your dishwasher, carefully read these user instructions and consult the wash programme chart. 12 BEFORE USING THE DISHWASHER • After unpacking, make sure the appliance is undamaged and that the door closes correctly. Do not use the appliance if it is damaged. If in doubt, consult your local retailer. Keep potentially hazardous packaging (plastic bags etc. ) out of the reach of children. [. . . ] The recommended dosage varies between different brands. The figures inside the large compartment serve as a dosage guide. The figures are in “ml” or “cm 3”. Only fill the detergent dispenser prior to starting a wash programme. For programmes with additional selected functions: “Half load”: load the upper or lower rack only. Use a smaller quantity of detergent. Normal load: For programmes with pre-rinse. (Example: Normal 65°C refer to the “Wash programme chart”). Pour two thirds of the recommended dosage in the large compartment. Pour the remaining third in the small compartment. Note: Remember to close the large compartment lid. Large compartment volume: 45 ml (up to rim). Small compartment volume: 10 ml (up to rim). For programmes without pre-rinse: • Pour the entire recommended dosage in the large compartment. If the recommended dosage on the detergent pack is over 45 ml, pour the remaining detergent in the small compartment. 16 HOW TO USE THE DISHWASHER Open the door and turn on the water tap. Press the I button (ON) to switch on the appliance. One of the programme indicator lamps will illuminate. 1 2. Press the programme selector button until the corresponding indicator lamp illuminates. If required, select any additional functions. 2 3. Press the Start button to start the selected wash programme. The Start indicator lamp will illuminate. Once set, the programmed data cannot be altered by pressing the buttons or programme selector button. Note: Once the Start button has been pressed, the dishwasher memorises all the programmes selected. [. . . ] Reassemble: Insert the cylindrical filter in the wide-mesh central filter. Fit the fine-mesh filter and screw down the filter unit by turning it clockwise. The filter unit must be correctly assembled to ensure good washing results. A B C 20 TROUBLESHOOTING GUIDE If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem. Restart the wash programme to see if the fault repeats. • Press the Start button for about 5 seconds until the Start indicator lamp switches off. [. . . ]