User manual WHIRLPOOL ADL 448/3 PRODUCT FICHE

[. . . ] Values may vary in relation to usage, e. g. : different loads, water temperatures - above or below 15°C - as well as water hardness and power supply voltage, etc. Important information for Test Laboratories: For detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@email. whirlpool. com”. 5019 596 92107 (We reserve the right to make technical modifications) IG/I/K/GB How to use the appliance Further indications are given in the single chapters and in the user instructions. Automatic start by turning the programme selector knob (in case of retractable knob, first press the knob to access it). Large compartment A: With each wash cycle. Switch on the appliance A B C How to fill the detergent Small compartment B: For programmes with pre-wash only. Check the rinse aid level Mechanical indicator C. [. . . ] Electric indicator on control panel (if provided). Load the racks Close the dishwasher door, turn on the water tap Select a programme Refer to the dishwasher loading instructions. Select the desired programme. The corresponding indicator lamp comes on. Select options If necessary (and if provided) the corresponding indicator lamp lights up. Press the Start button The selected programme is then memorised (even in the event of power failure). “Change programme” Press the START button for 2 sec. until the Start indicator lamp switches off; Select another programme and press the START button again. - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. Wash cycle Switch off the appliance Turn off the water tap, unload the racks Only after the START button has switched off: Access the knob (in case of retractable knob, press and then release the knob). Warning: when the door is opened steam comes out!Unload the appliance, starting from the lower rack. IG/II/K/GB Dishwasher loading instructions and racks provided Upper rack: Revolving glass support (A): Depending on the position, for example small or longstemmed glasses. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses. Lower rack: Plate holder (C). Cutlery basket (D): The cutlery basket can be removed to increase available space. • Use a good quality detergent. Sandy or grainy residues • Clogged filters. • Filters incorrectly assembled. • Check filters regularly/if necessary clean *. • Depending on the material, if necessary use a detergent with a greater whitening power. Colour of plastic parts faded Deposits on crockery • removable • Tomato/carrot juice, . . . • Streaks on the crockery/glasses. • Layer of salt on crockery/glasses. • Increase the rinse aid dosage *. • Close the salt container lid properly *. • Change water hardness setting, if necessary add salt *. • Use suitable glasses. • not removable • Insufficient water softening, calcium deposits. • Cannot be washed in the dishwasher. Opaque glasses/ glasses not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. • The START indicator lamp flashes. • Use suitable cutlery. [. . . ] • The START indicator lamp flashes. • Use suitable cutlery. • Ensure that the filter assembly is not clogged and if necessary clean it *. Press the Start button for 2 seconds, until the Start indicator lamp switches off. [. . . ]