User manual WHIRLPOOL ADL 842/2 WH INSTRUCTION FOR USE

[. . . ] 3. 0 Slightly to normally soiled textiles made of cotton and/or synthetics. Daily load 40 °C 40 °C Quick wash 30 °C Rapido 30 °C 3. 0 1. 0 Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton. Only woollens, labelled with the Woolmark and identified as machine washable. Wool Cold - 40 °C Lana a freddo - 40 °C Handwash 30 - 40 °C Lavaggio a mano 30 - 40 °C 1. 0 Textiles made of linen, silk, wool and viscose marked as “handwashable”. Yes Rinse & Spin Spin Drain Risciacquo & Centrifuga Centrifuga Scarico acqua — — — 7. 0 Same as the last rinse and the final spin in the “Cotton” programme. 7. 0 In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. — — — — Water is drained only without any spinning. — ❉: 1) 2) optional / Yes : dosing required For improved garment care, spin speed is restricted to 1000 rpm in this programme. [. . . ] The indication lamp next to the “Start” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phase is finished, the corresponding indication goes out. “DOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show that the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your Instructions for Use; if the fault persists, contact our After Sales Service. “Water tap closed” The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Clean pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). PROGRAMME END • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. Turn the programme selector to the “Off/O” position. Leave the door ajar to allow the drum to dry. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Press the “Start” button to pause the programme. Select the new programme (with temperature), any options and another spin speed if you want. Press the “Start” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. [. . . ] • This option is particularly suitable for areas with very soft water, washing baby linen and helps people with allergies. “Rinse hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. • This option is particularly recommended for the programmes “Synthetics”, “Daily load” and “Delicates”. • It is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. [. . . ]