User manual WHIRLPOOL ADN 230 INSTRUCTION FOR USE

[. . . ] 14 kWh/per year 748 781 Actual consumption will depend on how the appliance is used and where it is located. Total gross volume, L 290 350 Storage (net) volume, L 275 320 Extra data Overall dimensions, mm 1450x600x600 1730x600x600 2 Storage shelves area, dm 115 120 Weight, kg 67 85 Rated supply voltage, V 220- 230 Fluctuation of supply voltage, V 187-253 Frequency, Hz 50 Rated power input, W 200 230 Current, A 1, 5 1, 7 Foaming agent Cycle pentane SAFETY PRECAUTIONS Before connection the appliance to the mains, check whether the supply cord isn’t damaged. The plug of the appliance should be connected to the properly fixed, stationary socket providing a good contact. If the appliance is produced with the special supply cord, it can be exchanged only by the same special supply cord provided by the manufacturer. [. . . ] The door must slide easily by wheel’s surface. 10 SELECTION OF APPLIANCE POSITION The appliance should be placed in a dry well ventilated room on the flat ground. The appliance must be kept further from heat sources (furnaces, radiators and etc. Can’t touch heating, gas or other tubes and also heating devices. If it is impossible to select another place, use an insulating panel. 2 The green signal lamp 4 indicates that the appliance has been connected to the mains. The fan switches on and continuously operates in the appliance with a fan. The thermostat in "O" (switched off) position switches off from the mains only the compressor. Temperature in the storage compartment is adjusted by the thermostat knob 2. The thermostat is switched off when the knob on the thermostat scale 3 is turned to the position "0". Turning the thermostat knob clockwise, the temperature in the storage compartment is being reduced. € A thermometer placed inside the appliance shows an average temperature of the storage compartment. Keep ventilation openings, in the appliance enclosure or in the built - in structure, clear of obstruction. If doors of the appliance close badly, it is necessary to change the door gasket. If this requirement is not fulfilled, the temperature in the refrigerator rises and energy consumption in creases. Lighting of the storage compartment is switched on by pressing the switch 1. 11 STORAGE OF COOLED FOODSTUFFS Temperature in the storage compartment depends on the ambient temperature, on the position of the thermostat knob and on quantity of stored foodstuffs. At the beginning the knob of the thermostat should be turned to the position “3”. If foodstuffs are too cold - to the position “1”-“3”, if foodstuffs are not enough cold – to the position “3”-“5”. Liquids or foodstuffs absorbing or spreading odours should be stored in closed utensils. Before loading into the appliance, foodstuffs must be cooled to the room temperature. In order to guarantee normal operation of the appliance, clean it at least once a month with warm water or soap and soda solution. [. . . ] The appliance should be transported in the vertical position. Tightly fasten the appliance in order to avoid any moving or shocks in conveyance. For better repair service together with your written order or order by phone you should indicate data of your appliance. You can find them in the marking label of your appliance – see the fig. [. . . ]