User manual WHIRLPOOL ADN 605 INSTRUCTION FOR USE

[. . . ] Also, a high-sensitivity automatic differential switch must be installed which protects against direct or indirect contact with live electrical parts and against current leakage (maximum current leakage permissible by regulations is 1 mA/kW). • Connection to a power balance system for the installation in a all is given through a connection point. Follow the VDE 0100 T 410 connection rules or local rules. • Compare technical datas on grey stickers to those written on this manual and present power supply. [. . . ] Use this appliance only under constant control. Never use water to put out grease or oil!• Parts of the appliance and attachments exposed to food must be cleaned with detergents and rinsed thoroughly with potable water. • Do not clean the appliance using water jets or steam, whether direct or pressurized!• If the room is being cleaned with water/steam jets or high-pressure equipment, it is necessary to switch off the appliance first!• Before starting to clean the appliance, disconnect from the mains. • Do not use inflammable liquid to clean the appliance. • Repairs may be carried out only by skilled personnel. • During repairs, the appliance must undergo voltage omnipolar insulation (local switch, i. e. • Noise emission values of the appliance in operation are below 70dB (A). This value is compulsory according to certain national safety standards. The manufacturer declines all responsibility concerning mistakes included in these instructions due to translating or printing errors: the manufacturer also reserves the right to change the product as he see fits, though without changing its essential features. The manufacturer declines all responsibility for any non-compliance with the provisions contained in this manual. 0811_GB_42 - ELECTRIC CHIPS SCUTTLE 04/2008 7 · 12 6 - INSTRUCTIONS FOR USE Fig. 1 6. 5 Appliance care and frequency of maintenance Attention!When cleaning, carefully avoid washing the appliance with direct water jets or high-pressure water!Cleaning must be performed when the appliance is cold. Thorough daily cleaning of the appliance, after disconnecting it, will keep it in perfect working order and make it last longer. All steel parts should be cleaned with water and a detergent, using a damp cloth; do not use abrasive substances or corroding detergents. Do not use steel wool, which could cause rust to form. For the same reason, avoid touching the appliance with anything made of iron. Do not clean with sandpaper and lubricating gel paper. If absolutely necessary, you may use pumice powder. [. . . ] A on the adhesive label featuring the technical specifications applied on the actual product (the label also giving the serial number). This symbol indicates that the product is classified, according to the regulations in force, as an item of electrical and electronic equipment and conforms to EU Directive 2002/96/EC (WEEE) meaning that, at the end of its service life, it must be treated separately from domestic waste, i. e. it must be handed in free of charge to a separate waste electrical and electronic equipment collection centre or returned to the reseller when buying a new equivalent item of equipment. The user is responsible for delivering the unit at the end of its life to the appropriate collection facilities. Failure to do so shall result in the user being subject to the penalties prescribed by the legislation in force on waste. [. . . ]