User manual WHIRLPOOL ADN 612 INSTRUCTION FOR USE

[. . . ] 0813_GB_42 Instructions for installation, use e maintenance GAS KITCHENS WITH PILOT ADN 612 ADN 613 04/2008 CHARACTERISTICS Supplied by: Date: Customer Service: FAX e-mail 0813_GB_42 - GAS KITCHENS WITH PILOT 04/2008 2 · 16 INDEX 1 2 Diagram Characteristics of the appliances 4 5 5 7 7 7 7 7 7 7 7 7 7 7 7 8 8 8 8 8 8 8 8 8 8 8 8 8 8 9 9 9 9 10 10 10 10 10 10 10 6 Instructions for use 6. 1 Safety, cleaning and repair rules 6. 2 Start-up 6. 2. 1 Lighting and disconnecting flame burner with pilot 6. 3 Lighting and shutdown of gas oven GN 1/1 6. 4 Turning the appliance off in case of breakdown 6. 4. 1 What to do in case of failure 6. 4. 2 What to do in case of prolonged period of disuse 6. 5 Appliance care and frequency of maintenance 6. 6 Recommendations for handling “stainless steel” industrial kitchens 6. 6. 1 Useful information on “stainless steel” 6. 6. 2 Warnings and advice for maintenance of “stainless steel” appliances 6. 6. 3 WEEE Directive 11 11 11 11 11 11 11 11 11 12 12 12 13 3 Technical data 4 Installation instructions 4. 1 Safety rules 4. 2 Structure, framework and safety devices of the appliances 4. 2. 1 Cooking zone 4. 2. 2 Oven Gas version GN 1/1 4. 3 Assembly 4. 3. 1 Installation premises 4. 3. 2 Statutory regulations and technical requirements 4. 3. 3 Installation 4. 3. 4 Gas connection 4. 3. 5 Smoke extraction 5 Operation preparation 5. 1 Preparation and Start-up 5. 1. 1 Start-up 5. 1. 2 Check of power 5. 1. 3 Checking the input pressure 5. 1. 4 Power check with volumetric method 5. 1. 5 Power check for operation with liquid gas 5. 1. 6 Operation control 5. 1. 7 Check of pilot flame 5. 1. 8 Checking the primary air 5. 1. 9 Operator training 5. 1. 10 Conversion and adjustment 5. 1. 11 Replacement of open flames injectors 5. 1. 12 Replacement of pilot injectors of open flames 5. 1. 13 Setting reduced capacity power 5. 1. 14 Replacement of burner injector of gas oven GN 1/1 5. 1. 15 Setting reduced capacity power oven 5. 2 Maintenance 5. 3 Replacing parts 5. 3. 1 Open flame gas cock 5. 3. 2 Open flame thermocouple 5. 3. 3 Gas cock gas oven GN 1/1 5. 3. 4 Plug gas oven GN 1/1 5. 3. 5 Thermocouple gas oven GN 1/1 5. 3. 6 Main burner gas oven GN 1/1 0813_GB_42 - GAS KITCHENS WITH PILOT 04/2008 3 · 16 1 - DIAGRAM ADN 613 1000 ADN 612 800 700 60 0 0 0 0 0 0 0 0 0 0 0 0 Gas 1/2" 678 496 45 910 34 45 45 710 34 45 545 25 Data plate Gas 1/2" Gas 1/2" 55 34 34 700 Data plate 1000 800 700 Data plate 0813_GB_42 - GAS KITCHENS WITH PILOT 04/2008 4 · 16 150 2 - CHARACTERISTICS OF THE APPLIANCES These appliances are used for professional purposes. Installation, repair and use must be carried out by expert personnel. These instructions for installation are for our gas kitchens set up for the category in the table 1 on pag. The data plate is located on the appliance, see diagram. [. . . ] 2) fixing the thermocouple on the cock and put in a new piece (pos. 2) install in reverse order. 5. 3. 6 Main burner gas oven GN 1/1 Remove the front/lower panel by removing the fastening screws. Unscrew the screws fixing the hanger (pos. 2) and extract the injector-holder from its housing, unscrew the screws rear fixing (pos. 2) of the burner and put in a new piece in the reverse order. After the replacement check the seal using a leack detector spray. After any maintenance or repair work, replace the control panel and the lower panel. After replacing gas input components, check operation again and test for leakage. 5. 3 Replacing parts All parts must be replaced by authorized technicians only!To replace the following parts first remove all the control knobs and control panel (after loosening the fixing screws), then extract the ignition wire. 5. 3. 1 Open flame gas cock Loosen the fitting of the pipes (pos. 1) fixing the cock on the gas piping and replace the piece (pos. After the replacement check the seal using a leack detector spray. 5. 3. 2 Open flame thermocouple Loosen the nut (pos. 1) for fastening the thermocouple on the valve and on the burner (pos. 1) install in reverse order. 5. 3. 3 Gas cock gas oven GN 1/1 Loosen the fittings (pos. 2) which are for the connection for the gas pipe and the thermocouple, unscrew the screws (pos. 2) remove the coil of the thermostat from its place in the cooking chamber and put in a new piece in the reverse order. After the replacement check the seal using a leack detector spray. 5. 3. 4 Plug gas oven GN 1/1 Unscrew the fastening screws and remove the lower panel, extract the ignition wire and unscrew the screws (pos. 2) install in reverse order. 0813_GB_42 - GAS KITCHENS WITH PILOT 04/2008 10 · 16 6 - INSTRUCTIONS FOR USE 6. 1 Safety, cleaning and repair rules • This appliance is used for the preparation of meals at industrial level. Usage and cleaning can be carried only by expert personnel. Maintenance and repair can be carried out only by skilled technical personnel. • These indications must be communicated to all those concerned during internal training. This appliance must be constantly watched over when being used!• Grease and overheated oil can catch fire. [. . . ] If no specific cleaning recommendations are available, it is necessary, however, to use detergents having a low chloride content. After cleaning, remove all soap residues with plenty of clean water and thoroughly dry the surfaces. • Minimize contact of “stainless steel” with concentrated acids, spices, salts, etc. Even acid vapours coming from cleaning the tiles favour “stainless steel” corrosion. [. . . ]