User manual WHIRLPOOL ADN 627 INSTRUCTION FOR USE

[. . . ] Feinwäsche 20 - 60 °C 20 - 30 °C 20 - 40 °C 4. 0 Slightly to normally soiled textiles made of cotton and/or synthetics. 4. 0 Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton. 1. 5 Curtains and delicate clothing, dresses skirts, shirts and blouses. Normally to heavily soiled and robust bed linen, table linen and underwear, towels, shirts etc. Offers highest economy in energy consumption by prolonged wash duration. [. . . ] • The time delay indication disappears when the programme starts and it is replaced by the remaining programme time. • Once having pressed the “Start” button, the number of hours preselected can be reduced by pressing and holding the “Start delay” button. From 1 hour on, the delay time can also be reduced by minutes. To cancel the “Start delay” . . . before you press the “Start” button: • Turn the programme selector to another position or press the “Reset” button. . . . after having pressed the “Start” button: • Press the “Reset” button for at least 3 seconds - the start delay time disappears from the display. RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your Instructions for Use. If the fault persists, contact our After Sales Service. “Water tap closed” The appliance has no or insufficient water supply. If the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Clean pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned. In the latter case refer to the Instructions for Use (“Removing the Filter”). Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The time indicated on the display can deviate from the values in the table, because it takes into account the household conditions applicable at that time. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. *** Reference Programme for Energy Label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. Turn the programme selector to the desired programme. The display shows the programme duration in hours and minutes as well as the predefined temperature. The temperature can be altered by pressing the “Temperature” button. The indication lamp of the predefined spin speed lights up. In case you want to set another spin speed, press the “Spin” button. “Easy ironing” button • Can be used together with “Cotton”, “Synthetics” and “Daily load” programmes to make ironing easier. • Increases the water quantity and the clothes are spun very gently. [. . . ] The programme will terminate automatically with the final spin cycle for the present wash programme. • If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the “Start” button. PROGRAMME START Open the tap and press the “Start” button. The indication lamp next to the “Start” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. [. . . ]