User manual WHIRLPOOL ADP 2315 BL PRODUCT FICHE

[. . . ] •Check with a qualified electrician or service representative if you are not sure whether the appliance is properly earthed. Do not modify the plug provided with the appliance if it does not fit the outlet; have a proper outlet installed by a qualified electrician. WARNING: PROPER USE •Do not abuse, sit on, or stand on the door or dishrack of the dishwasher. •Do not operate your dishwasher unless all enclosure panels are properly in place. Open the door very carefully if the dishwasher is running, there is a risk of water squirting out. [. . . ] Refer to the figure below for reference. Put the 3in1 tablet into the container, then start the 3in1 program. NOTE When using 3in1 combination / compact detergents, please make sure that the size of the combination detergents fits the dispenser, so that combination detergents can be easily put into the dispenser, without breaking it. 12 LOADING THE DISHWASHER BASKET For optimum dishwasher performance, follow these loading guidelines. Features and appearance of baskets and cutlery racks may vary from your model. Attention: before or after loading the Dishwasher Racks Scrape off any large amounts of leftover food. It is not necessary to rinse the dishes under running water. Place objects in the dishwasher in following way: 1. Items such as cups, glasses, pots/pans, etc. Curved items, or ones with recesses, should be tilted so that water can run off. All utensils should be stacked securely so that they do not tip over. All utensils are placed in such a way that the spray arms can rotate freely during washing. Very small items should not be washed in the dishwasher as they could easily fall out of the racks. The door should not be left in the open position as this could present a tripping hazard. 15 STARTING A WASHING PROGRAMME Wash Cycle Table NOTE Meaning: need to fill the Rinse Aid Dispenser • • * En50242: This program is the test cycle, the recommended rinse aid dispenser setting is position 6. • The power consumption of off-mode is 0W, stand-by mode is 0. 73W. Program Cycle selection information Description Detergent of cycle pre/main Pre-wash (50°C) Wash (65°C) Rinse Rinse Rinse (55°C) Drying Pre-wash (55°C) Wash (55°C) Rinse Rinse (65°C) Drying Wash (45°C) Rinse (70°C) Drying Running Energy Water Rinse time (kWh) (l) (min) Intensive For heaviest soiled crockery, and normally soiled pots, pans, dishes, etc with dried on soiling. 3/22 g 120 1. 13 16. 0 Daily For normally soiled loads, such as pots, plates, glasses and lightly soiled pans. 3/22 g 155 1. 09 13. 0 For dishes that need to be rinsed and dried only. Hygiene — 98 0. 8 8. 0 Eco Standard daily cycle for normally soiled loads, such as pots, plates, glasses. Pre-wash Wash (55°C) Rinse Rinse (65°C) Drying Wash (40°C) Rinse Rinse (40°C) Pre-wash Wash (40°C) Rinse Rinse (60°C) Drying 3/22 g 170 0. 93 14. 0 A shorter wash for lightly soiled loads and quick wash. Rapid For lightly soiled crockery and glass Fragile To rinse dishes that you plan to wash later that day. Pre-wash For the heaviest soiled loads, such as pots, pans, casserole, dishes and dishes that have been sitting with dried food on them for a while. For normally soiled loads, such as pots, plates, glasses and lightly soiled pans. 25 g 30 0. 5 9. 0 — 25 g 95 0. 71 13. 0 Pre-wash — 8 0. 01 3. 0 — + Intensive + 3in1 Pre-wash (50°C) Wash (65°C) Rinse Rinse Rinse (65°C) Drying Pre-wash (50°C) Wash (55°C) Rinse Rinse (65°C) Drying Pre-wash Wash (50°C) Rinse (65°C) Drying 3in1 1pcs 120 1. 13 16. 0 — + Daily + 3in1 3in1 1pcs 150 1. 08 13. 5 — + Eco + 3in1 For lightly soiled loads such as plates, glasses, bowls and lightly soiled pans. 3in1 1pcs 160 0. 84 10. 5 — 16 Turning On the Appliance Starting a cycle wash: 1. Draw out the lower and upper racks, load the dishes and push them back. It is advisable to load the lower rack first, then the upper one (see the section entitled "Loading the dishwasher"). Pour in the detergent (see the section entitled "Salt, detergent and rinse aid"). The power supply is 220-240 VAC /50 HZ, the specification of the socket is 10A 250 VAC. Make sure that the water supply is turned on to full pressure. [. . . ] See "Wash Cycle Table". The dishes are not The dishes were not clean loaded correctly The program was not powerful enough Not enough detergent was Use more detergent, or change your detergent. dispensed Items are blocking the path of spray arms Rearrange the items so that the spray arm can rotate freely. The filter combination in Clean and/or fit the filter combination correctly. Clean the washing cabinet base is the spray arm jets. See "Cleaning the Spray Arms". [. . . ]