User manual WHIRLPOOL ADP 2315

[. . . ] Quick reference guide Chart BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON. FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF ANY CYCLE IS STARTED. PROGRAMME SELECTION BUTTON Push "Programs" button (repeatedly) until the indicator of the required programme lights up (see "Table of programmes" below). START/RESUME BUTTON Push this button to start the selected programme: the indicator lights up and goes off at the end of the programme. When the door is opened during a washing cycle, the cycle is temporarely paused: the Start indicator blinking. [. . . ] If it has, the appliance will only start once the set time has elapsed. If necessary, set the delayed start to "0" (RESET the appliance). - The water inlet hose must not be kinked and the relative inlet filter in the water tap connector must not be dirty or clogged. - The water tap must be fully open during water inlet (minimum capacity: 0. 5 litres per minute). - The filters must not be dirty or clogged. bowls, cups) must be arranged facing downwards in the rack. - The drain hose must be fitted correctly (for high mounted appliances, leave min. 200-400 mm from the lower edge of the appliance) - see Assembly instructions. - Repeat without detergent or wait until foam disappears. - The closure disk of the syphon hose connection must be removed. - . . . the indicator lamp blinks 6 times - . . . the indicator lamp blinks 6 times and wash programme ended too early (dishes are dirty and wet) . . . the indicator lamp blinks 8 times - - After taking the above course of action, the fault message must be reset. In the majority of cases the fault is thus eliminated. Water drains automatically for up to 30 seconds. - Close the salt reservoir cap properly. - If you use a combined action detergent, try adding more rinse aid. - Synthetic materials do not dry well; if wet at end of cycle, wipe dry. Clean dishes left in dishwasher for a long time after end - In this situation, the presence of drops of water on dishes and on the sides of the dishwasher is normal. when using "Delayed start" option). T releasing the door 5 minutes before removing the dishes. ry Incorrect arrangement of the concave items in the rack. - Arrange crockery so that water does not collect in cavities. - Increase the dosage of rinse aid (see page 3, "Adding rinse aid"). - The rapid programme is intended for quickly washing lightly soiled dishes. If used for a full load of medium/ heavy soiled dishes, the dishes may not dry completely. [. . . ] knives), must be placed in the cutlery basket with the sharp end facing downwards. Long-handled utensils must be arranged horizontally in the upper rack, with the sharp end facing away from the front of the appliance. The guarantee is not applicable if faults are caused by incorrect use of the appliance. - Before cleaning or carrying out maintenance, disconnect the mains plug and turn off the water tap; also in the event of any malfunction. [. . . ]