User manual WHIRLPOOL ADP 4400 WH PRODUCT FICHE

[. . . ] Electric indicator on control panel (if provided). Check the regeneration salt level On models with water softener system only. Electric indicator on control panel (if provided). Load the racks Close the dishwasher door, turn on the water tap Select a programme Refer to the dishwasher loading instructions. Select the desired programme. The corresponding indicator lamp comes on. Select options If necessary (and if provided) the corresponding indicator lamp lights up. Press the Start button The selected programme is then memorised (even in the event of power failure). “Change programme” Press the START button for 2 sec. until the Start indicator lamp switches off; Select another programme and press the START button again. [. . . ] - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. Wash cycle Switch off the appliance Turn off the water tap, unload the racks Only after the START button has switched off: Access the knob (in case of retractable knob, press and then release the knob). Warning: when the door is opened steam comes out!Unload the appliance, starting from the lower rack. WH/II/K/GB Dishwasher loading instructions and racks provided Upper rack: Multi-purpose support (A): 1) Depending on the position, for long-handles utensils, cups and glasses. May be used in three different positions. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses. Revolving glass support (C): 2) Depending on the position, for example small or long-stemmed glasses. depending on the model Half Load: Load the upper rack only. Place the cutlery basket (D) in the upper rack. Rack height adjustment (also when loaded): • Lower adjustment: pull out the two rack handles outwards (E) and lower the rack. • Select a more intense wash cycle. • The spray arms must be able to turn freely. • Spray arm nozzles clogged. • Remove any impurities obstructing the water flow *. • Incorrect detergent/detergent too old. • Use a good quality detergent. Sandy or grainy residues • Clogged filters. • Filters incorrectly assembled. • Check filters regularly/if necessary clean *. • Depending on the material, if necessary use a detergent with a greater whitening power. Colour of plastic parts faded Deposits on crockery • removable • Tomato/carrot juice, . . . • not removable • • • • Streaks on the crockery/glasses. Insufficient water softening, calcium deposits. • • • • Increase the rinse aid dosage *. Close the salt container lid properly *. Change water hardness setting, if necessary add salt *. Opaque glasses/ glasses • Cannot be washed in the dishwasher. [. . . ] Change water hardness setting, if necessary add salt *. Opaque glasses/ glasses • Cannot be washed in the dishwasher. not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. • The START indicator lamp flashes. • Use suitable glasses. • Use suitable cutlery. • Ensure that the filter assembly is not clogged and if necessary clean it *. [. . . ]