User manual WHIRLPOOL ADP 5100 IX PROGRAM CHART

[. . . ] Quick reference guide Chart BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED. (see at right for options description) PROGRAM SELECTION BUTTON Push “Programs” button (repeatedly) until the indicator of the required program lights up (see “Table of programs” below). START/RESUME BUTTON Push this button to start the selected program: the indicator lights up and goes off at the end of the program. [. . . ] How the faults are shown on the display: The appliance. . . . . . is not working/will not start Function number “F”x - blinking Possible causes. . . The appliance must be switched on. The dishwasher door doesn’t close. Possible causes. . . Too little space between dishes (incorrect arrangement of the concave items in the rack). T little detergent; detergent too old or incorrectly stored. oo Temperature not high enough for heavily soiled crockery. Loading of the dishwasher using lower and upper rack at the same time with “Half load/Multizone” option. Clogged spray arms, dirty filters or not fitted correctly. Spray arms stuck impeded by crockery or cutlery. . . . are not perfectly clean/have food residues - Solutions. . . Arrange crockery so that items do not touch each other. bowls, cups) must be arranged facing downwards in the rack. If necessary, use more detergent, observing the manufacturer’s indications as regards dosage. Always store detergent in a dry place and do not store it for excessively long periods of time. For heavily soiled crockery, select a wash program with a higher temperature (see table of programs - page 1). If you select the “Half load/Multizone” option (if available), remember to load only the upper rack or only the lower rack to increase washing power and thus obtain optimum wash results. In the event of frequent use of the Eco 50°C program (if available), from time to time select the Intensive 70°C program (if available). The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see page 5, “Maintenance and care“). The spray arms must be able to turn freely and must not be impeded by crockery or cutlery. GB -6- What to do if. . . Crockery and cutlery. . . . . . salt indicator lit . . . have deposits: regeneration salt residue . . . are not dry Possible causes. . . - Set “Tablet” option; if this option is not available, it is normal for the salt indicator to light up. - In areas with very hard water, more regeneration salt needs to be added (see page 2, “How to set water hardness”). - Close the salt reservoir cap properly. [. . . ] knives), must be placed in the cutlery basket with the sharp end facing downwards. Long-handled utensils must be arranged horizontally in the upper rack, with the sharp end facing away from the front of the appliance. The guarantee is not applicable if faults are caused by incorrect use of the appliance. - Before cleaning or carrying out maintenance, disconnect the mains plug and turn off the water tap; also in the event of any malfunction. [. . . ]