User manual WHIRLPOOL ADP 5350 PC IX PRODUCT FICHE

[. . . ] The dishwasher will start at the set time. Pre-Rinse Washing Drying Programme end Programme chart Programmes Loading instructions Automatic programme recommended for Sensor Normal 40-55°C routine washes, with no dried-on or burnt food (not for EN 50242). Automatic programme recommended for Sensor Intensive 60-70°C heavily soiled crockery with dried-on or burnt food, for example pans and saucepans. Detergent 2) A X X X X X Consumption 3) Litres kWh Minutes B X X X 10. 0-13. 0 0. 80-1. 05 50-110 13. 0-20. 0 1. 10-2. 00 90-140 4. 0 10. 0 10. 0 13. 0 0. 03 0. 80 0. 65 1. 05 14 55 30 120 Pre-Rinse Glasses Quickwash Eco-Normal 1) 1) 2) cold Crockery to be washed later. 40°C Light soiling, for example glasses and cups. 40°C Lightly soiled crockery with no dried-on food. 50°C Normally or heavily soiled crockery. 3) Reference programme for energy label in compliance with EN 50242 regulations; Refer to “User instructions“; Values may vary in relation to usage, e. g. : different loads, water temperatures - above or below 15°C - as well as water hardness and power supply voltage, etc. Whirlpool is a registered trademark of Whirlpool USA 5019 396 91189 (We reserve the right to make technical modifications) WH/I/K/GB How to use the appliance Further indications are given in the single chapters and in the user instructions. [. . . ] Large compartment A: Switch on the appliance How to fill the detergent With each wash cycle. Small compartment B: For programmes with pre-wash only. A B C Check the rinse aid level Mechanical indicator lamp C. Electric indicator on control panel (if provided). Check the regeneration salt level On models with water softener system only. Electric indicator on control panel (if provided). Load the racks Close the dishwasher door, turn on the water tap Select a programme Refer to the dishwasher loading instructions. Select the desired programme. The corresponding indicator lamp comes on. Select options If necessary (and if provided) the corresponding indicator lamp lights up. Press the Start button The selected programme is then memorised (even in the event of power failure). “Change programme” Press the START button for 2 sec. until the Start indicator lamp switches off; Select another programme and press the START button again. - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. Wash cycle Switch off the appliance Turn off the water tap, unload the racks Only after the START button has switched off: Access the knob (in case of retractable knob, press and then release the knob). Warning: when the door is opened steam comes out!Unload the appliance, starting from the lower rack. WH/II/K/GB Dishwasher loading instructions and racks provided Upper rack: Multi-purpose support (A): 1) Depending on the position, for long-handles utensils, cups and glasses. • Arrange crockery so that items do not touch each other. • Follow recommended detergent dosage. • Select a more intense wash cycle. • The spray arms must be able to turn freely. • Spray arm nozzles clogged. • Remove any impurities obstructing the water flow *. • Incorrect detergent/detergent too old. • Use a good quality detergent. Sandy or grainy residues • Clogged filters. • Filters incorrectly assembled. • Check filters regularly/if necessary clean *. • Depending on the material, if necessary use a detergent with a greater whitening power. Colour of plastic parts faded Deposits on crockery • removable • Tomato/carrot juice, . . . • not removable • • • • Streaks on the crockery/glasses. Insufficient water softening, calcium deposits. • • • • Increase the rinse aid dosage *. Close the salt container lid properly *. [. . . ] Change water hardness setting, if necessary add salt *. Opaque glasses/ glasses • Cannot be washed in the dishwasher. not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. • The START indicator lamp flashes. • Use suitable glasses. • Use suitable cutlery. • Ensure that the filter assembly is not clogged and if necessary clean it *. [. . . ]