User manual WHIRLPOOL ADP 5755 SL INSTRUCTION FOR USE

[. . . ] Quick reference guide Chart BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON. FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF ANY CYCLE IS STARTED. PROGRAMS SELECTION BUTTON Push “Programs” button (repeatedly) until the indicator of the required program lights up (see “Table of programs” - next page). HALF LOAD BUTTON Half load cycle can be used for the upper or lower rack. Select the required programme then press the “Half Load” button - the light comes on. [. . . ] Clean spray nozzles under running water (use toothpicks if necessary). . . Spray arms Remove blockages/ deposits. GB -8- What to do if. . . If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the courses of action, quickly restoring normal appliance operation. Crockery and cutlery. . . . . . is not working/will not start Possible causes. . . - The appliance must be switched on. - The dishwasher door doesn’t close. - Solutions. . . - Arrange crockery so that items do not touch each other. bowls, cups) must be arranged facing downwards in the rack. . . . salt indicator lit - . . . have deposits: regeneration salt residue . . . are not dry - - - If necessary, use more detergent, observing the manufacturer’s indications as regards dosage. Always store detergent in a dry place and do not store it for excessively long periods of time. Temperature not high enough for heavily - For heavily soiled crockery, select a wash program with a higher temperature (see soiled crockery. Table of programs - chapter “Chart” - page 2). Loading of the dishwasher using lower and - If you select the “Half load/Multizone” option (if available), remember to load only upper rack at the same time with “Half the upper rack or only the lower rack to increase washing power and thus obtain load/Multizone” option. - In the event of frequent use of the Eco 50°C program (if available), from time to Frequent use of Eco 50°C. time select the Intensive 70°C program (if available). Clogged spray arms, dirty filters or not - The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly. fitted correctly (see page 8, “Maintenance and care“). Spray arms stuck impeded by crockery or - The spray arms must be able to turn freely and must not be impeded by crockery cutlery. - Set “Tablet” option; if this option is not available, it is normal for the salt indicator to light up. - In areas with very hard water, more regeneration salt needs to be added (see page 3, “How to set water hardness”). - Close the salt reservoir cap properly. - If you use a combined action detergent, try adding more rinse aid. - Synthetic materials do not dry well; if wet at end of cycle, wipe dry. Clean dishes left in dishwasher for a long - In this situation, the presence of drops of water on dishes and on the sides of the time after end of cycle (e. g. Try releasing the door 5 minutes before removing the dishes. [. . . ] - Sharp items that might cause injury (e. g. knives), must be placed in the cutlery basket with the sharp end facing downwards. Long-handled utensils must be arranged horizontally in the upper rack, with the sharp end facing away from the front of the appliance. We reserve the right to make technical modifications. [. . . ]