User manual WHIRLPOOL ADP 6342 A PC WH INSTRUCTION FOR USE

[. . . ] Water connection Connection to the mains water supply must be carried out by a qualified technician in compliance with the manufacturer's instructions and applicable local safety regulations. All local water board regulations must be complied with. The inlet hose must be securely clamped to the water tap to prevent leaks. [. . . ] Do not cut hoses and, in the case of appliances fitted with a waterstop system, do not immerse the plastic casing containing the inlet hose in water. Before using the appliance for the first time, check the water inlet and drain hose for leaks. Electrical connection All local electricity board regulations must be complied with. Voltage information is shown on the rating plate mounted inside the door on the right hand side. The appliance must be earthed as prescribed by law. Do not use extension leads or multiple adapters. If the power cable is damaged, replace it with an identical one. The power cable must only be replaced by a qualified technician. After appliance installation, the mains plug must be easily accessible so that the appliance can be unplugged if necessary at any time. Para Austria: If a fault current switch is fitted upline of the appliance, this must be pulse current-sensitive. 3. - Assembly instruction During assembly the appliance must be unplugged from the mains. Set any electrical screwdrivers to a low torque. Attention: when transporting and assembling the appliance, always wear gloves to protect fingers / hands from sharp edges and corners. Be careful with uneven installation surfaces: regulate the foot height. For dishwashers with decor panel, fit the decor panel before the rounded plinth. The decor panel, if not supplied, is available from After-Sales Service. [. . . ] Do not use abrasive products or alcohol on the control panels. All sizes in this installation instruction are given in millimetres. Packaging varies according to the dishwasher mode. [. . . ]