User manual WHIRLPOOL ADP 6914 WH SPACE PRODUCT FICHE

[. . . ] With each successive touch of the button, the delayed start indicator increases by 1 hour, and after 24 returns to 00. The dishwasher will start at the set time. Wash cycle Pre-Rinse Washing Drying Programme end Programme chart Programmes Sensor Normal Sensor Intensive Pre-Rinse Glass Quickwash Normal 1) Antibacterial 4) 5) 1) 2) 3) Detergent 2) Loading instructions A X Consumption 3) Litres kWh Minutes 50-110 60-120 B X Automatic programme recommended for 40-55°C routine washes, with no dried-on or burnt food (not for EN 50242). 10. 0-13. 0 0. 80-1. 05 60-70°C heavily soiled crockery with dried-on or burnt food, for example pans and saucepans. Light soiling, for example glasses and cups. Lightly soiled crockery with no dried-on food. [. . . ] Values may vary in relation to usage, e. g. : different loads, water temperatures - above or below 15°C - as well as water hardness and power supply voltage, etc. 4) 5) The bacteria removal efficiency has been tested by the Institut Pasteur de Lille (France), based on the NF EN 13697 standard of November 2001. the door being opened) may compromise the result of the antibacterial rinse. Important information for Test Laboratories: For detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool. com”. Whirlpool is a registered trademark of Whirlpool USA 5019 396 91540 (We reserve the right to make technical modifications) WH/I/K/GB How to use the appliance Further indications are given in the single chapters and in the user instructions. Turn the knob: the appliance will switch on automatically (if the knob is retractable, press it to pop it out). Compartment A: Switch on the appliance Fill the detergent dispenser With each wash cycle. Compartment B: For programmes with pre-wash only. A BC Check the rinse aid level Mechanical indicator lamp C. Electric indicator on control panel (if provided). Check the regeneration salt level On models with water softener system only. Electric indicator on control panel (if provided). Load the racks Close the dishwasher door, turn on the water tap Select a programme Refer to the dishwasher loading instructions. Select the desired programme. The corresponding indicator lamp comes on. Select additional options If necessary (and if provided). The corresponding indicator lamp lights up. “Change programme in progress” Press the Start button The selected programme is then memorised (even in the event of power failure). Press the START button for 2 sec. • The water jet does not reach the crockery. • • • • • • Increase dosage *. • Load crockery at an angle. • Arrange crockery so that items do not touch each other. • Follow recommended detergent dosage. • Select a more intense wash cycle. • The spray arms must be able to turn freely. • Remove any impurities obstructing the water flow *. • Check filters regularly/if necessary clean *. • Depending on the material, if necessary use a detergent with a greater whitening power. Sandy or grainy residues Colour of plastic parts faded Deposits on crockery • removable • Clogged filters. • Tomato/carrot juice, . . . • not removable • • • • Streaks on the crockery/glasses. [. . . ] • Tomato/carrot juice, . . . • not removable • • • • Streaks on the crockery/glasses. Insufficient water softening, calcium deposits. • • • • Increase the rinse aid dosage *. Close the salt container lid properly *. Change water hardness setting, if necessary add salt *. Opaque glasses/ glasses not sparkling Rust on cutlery Identifying appliance faults • Cannot be washed in the dishwasher. • Use suitable glasses. • Not made of stainless steel. [. . . ]