User manual WHIRLPOOL ADP 6966 ECO IX PRODUCT FICHE

[. . . ] Lightly soiled crockery with no dried-on food. Light soiling, especially glasses and cups. X X (11. 5) (1. 3) 0. 02 (0. 02) 0. 85 (0. 75) 0. 82 (0. 78) 1. 05 (0. 90) 9 30 60 120 (90) (9) (30) (59) (117) Pre-wash Rapid 40° C Glasses 40° C Standard 50° C 1) 2) 2) X X X X 5. 0 13. 0 12. 5 16. 0 (4. 2) (13. 0) (10. 5) (14. 5) Normally or heavily soiled crockery with dried-on food. Values may vary in relation to usage, e. g. : different loads, water temperatures - above or below 15° C - as well as water hardness and power supply voltage etc. Reference programme for Test Institute and energy-label. 5019 100 91277 (We reserve the right to make technical modifications) How to use the dishwasher 1. After loading the dishwasher, close the door properly and open the water supply tap. [. . . ] Once set, the programmed data cannot be altered by turning the programme selector knob. Note: once the Start button has been pressed, the dishwasher memorises the last programme selected. This information remains in the memory even during interruption of the power supply. To change the selected programme, press the Start button for about 5 seconds. The Start indicator lamp will switch off. Select a new programme and press the Start button. Note: if the dishwasher is switched off during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted. Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. To indicate the end of the programme, the Start indicator lamp switches off and the End indicator lamp (if fitted) lights up (for about 30 min. ). Once the Start indicator lamp has switched offturn the programme selector knob to the initial position to switch off the dishwasher. Open the door (warning: beware of hot steam). Are the filters clogged or incorrectly assembled?(See “Care and Maintenance” chapter in the user instructions). Are the spray arms blocked or the nozzles clogged?(See “Care and Maintenance” chapter in the user instructions). Is the lower spray arm correctly fitted?Is the salt container cap (water softening system) screwed down?Is the water hardness level selector not properly adjusted?See (“Filling the salt container” in the user instructions). (See “Filling the salt container” in the user instructions). (See “Filling the detergent dispenser” in the user instructions). (See “Filling the rinse aid dispenser” in the user instructions). AFTER-SALES SERVICE If after carrying out the above checks the malfunction persists or appear s again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). [. . . ] • Has the Start button been pressed?• Has the delayed start timer been set (if fitted)?• Is the flow of water obstructed by impurities?If so, close the water supply tap, detach the water hose and clean the filter. [. . . ]