User manual WHIRLPOOL ADP 7406 WH WP INSTRUCTION FOR USE

[. . . ] Select another programme and press the START button again. Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. Only after the START button has switched off: Press the ON / OFF button. Warning: When the door is opened steam comes out! [. . . ] Check the safety circuit breaker. • Starting the selected programme. • The programme can be set to “0” to start. • Arrange crockery so that items do not touch each other. • Follow recommended detergent dosage. • Select a more intense wash cycle. • The spray arms must be able to turn freely. • Remove any impurities obstructing the water flow *. If crockery is not perfectly dry • Insufficient rinse aid. • Residual water in cavities. If crockery is not perfectly clean • The water jet does not reach the crockery. • Spray arm nozzles clogged. • Incorrect detergent/detergent too old. • Use a good quality detergent. Sandy or grainy residues • Clogged filters. • Filters incorrectly assembled. • Check filters regularly/if necessary clean *. • Depending on the material, if necessary use a detergent with a greater whitening power. Colour of plastic parts faded Deposits on crockery • Removable • Tomato/carrot juice, . . . • Streaks on the crockery/glasses. • Layer of salt on crockery/glasses. • Increase the rinse aid dosage *. • Close the salt container lid properly *. • Change water hardness setting, if necessary add salt *. • Not removable • Insufficient water softening, calcium deposits. Opaque glasses/ glasses • Cannot be washed in the dishwasher. not sparkling Rust on cutlery Identifying appliance faults • Not made of stainless steel. • The START indicator lamp flashes. (if provided). • Use suitable glasses. • Use suitable cutlery. • Ensure the filter assembly is not clogged and that there is no interruption to the water supply (if necessary, clean the filters *). Press the START button for 2 seconds, until the START indicator lamp switches off. Select a new programme and press the Start button again. If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). [. . . ] If the temperature is not maintained during the antibacterial cycle (e. g. if the door is opened and remains open for a long time), the lamp will start blinking to indicate that sanitation is not guaranteed. Programme chart Programmes Loading instructions Detergent 2) A X X X X Consumption 3) Litres kWh Minutes B X X X Pre-Rinse Quickwash Eco 1) 5) 6) (*) Daily 5) (*) Intensive 5) 1) 2) 3) cold 40°C 50°C 60°C 70°C Crockery to be washed later. Lightly soiled crockery with no dried-on food. Recommended programme for heavily soiled crockery, especially suitable for pans and saucepans. 5. 0 13. 0 16. 0 16. 0 17. 0 0. 02 0. 70 1. 05 1. 35 1. 65 10 30 195 120 145 Reference programme for energy label EN 50242; 4) The bacteria removal efficiency has been tested by the Institut Refer to “User instructions”; Pasteur de Lille (France), based on the NF EN 13697 standard of The data relevant to programmes are values obtained in the November 2001. [. . . ]