User manual WHIRLPOOL ADP 746/2 WH INSTRUCTION FOR USE

[. . . ] • Store the detergent, rinse aid and salt in a dry place out of the reach of children. General recommendations • Only use detergents, rinse aids and regeneration salts (not applicable for Australia) specially recommended for use in domestic dishwashers. • On completion of the wash programme switch off the dishwasher and turn off the water tap. • Before cleaning or carrying out maintenance, switch off the appliance, disconnect the mains plug and turn off the water tap. [. . . ] If crockery is prone to whitish streaks, reduce the dosage by turning the dial to a lower setting. If instead crockery is wet, increase the dosage by turning the dial to a higher setting. HOW TO FILL THE DETERGENT DISPENSER Only use detergents recommended for use in domestic dishwashers. If you use detergents in pellet form, follow the manufacturer’s directions for use. Always use the recommended dosage stated on the detergent pack. The use of detergent in excess of the recommended dosage may cause pollution. The recommended dosage varies between different brands. Only fill the detergent dispenser prior to starting a wash programme. Pour two thirds of the recommended dosage into the inner compartment A. Pour the remaining third into the small compartment B. For programmes without pre-rinse: • Pour the entire recommended dosage into the wider compartment. Adjust detergent quantity between Min and Max according to the wash load. Note: Remember to close the detergent dispenser lid. 13 CONNECTIONS Refer to the separate installation instructions booklet. Water inlet and drain: • Strictly follow local Water Board regulations. • Make sure the inlet and drain hoses are kinkfree and are not crushed. • If the hose length does not suffice, replace with similar hoses obtained from your local dealer or our After-Sales Service. • The inlet hose must be securely clamped to the water tap to prevent leaks. • The inlet water temperature varies according to the model installed: inlet hose marked “25° C”. All other models: maximum temperature 60° C. • When installing the appliance, make sure the drain water discharges correctly and, if necessary, remove the wire gauze from the sink siphon. • Secure the drain hose with a clamp to the siphon to prevent it from dropping off during operation. • For appliances with water-stop system only: if the water connections are made correctly, the water-stop system safeguards your home against damage caused by flooding. Electrical connections: • Closely adhere to local Electricity Board regulations. [. . . ] • Make sure the water hose filter is not clogged. To do this, turn off the water tap, disconnect the water hose, clean the filter, reconnect the water hose to the tap and turn on the tap. When loading large items in particular, make sure the water circulates and does not collect inside them. Crockery still dirty after washing: • Have you selected the correct programme? [. . . ]