User manual WHIRLPOOL ADP 7652 A 6S WH PRODUCT FICHE

[. . . ] • Before scrapping, cut off the power cable so that the appliance cannot be connected to the mains. PRECAUTIONS AND GENERAL RECOMMENDATIONS 1. Child safety: Children must not be allowed to play with the dishwasher. Store the detergent, rinse aid and salt in a dry place out of the reach of children. General recommendations: The open dishwasher door can only support the weight of the loaded rack when pulled out. [. . . ] • Fix the drain hose to the spigot with a clamp to prevent it from coming off during operation. • For appliances with water-stop system only: if the water connections are made correctly, the water-stop system safeguards your home against damage caused by flooding. Electrical connection: • Closely adhere to local Electricity Board regulations. • Voltage information is shown on the rating plate mounted inside the door on the right hand side. • The appliance must be earthed as prescribed by law. • Do not use extension leads or multiple adapters. • Before carrying out maintenance, disconnect the mains plug. • The power cable must only be replaced by a qualified technician. • For Austria: if the apparatus is series connected to a fault current switch, this must be sensitive to the pulsating current. 12 ELECTRICAL CONNECTION For Great Britain Only The wires in the mains lead are coloured in accordance with the following code: BLUE - “NEUTRAL” (“N”) BROWN- “LIVE” (“L”) GREEN AND YELLOW - “EARTH” (“E”) 1. The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the letter “E” or by the Earth symbol yellow. The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured black. Before using the dishwasher for the first time, fill the rinse aid dispenser. How to fill the rinse aid dispenser: Only use rinse aids recommended for use in domestic dishwashers. Press button A to open the cover (see drawing). Fill the dispenser with rinse aid up to the dashed line “max” (about 100 ml. ). Immediately wipe away any rinse aid spilt accidentally. This prevents the formation of excess suds which may spoil washing results. Thereafter, regularly check the rinse aid level. How to adjust the rinse aid dosage regulator: Factory setting: position 4. If you are not satisfied with washing or drying results, change the rinse aid dosage setting. Press button A to open the cover (see drawing). If crockery is prone to whitish streaks, reduce the dosage by turning the dial to a lower setting (1-3) using a coin or the like. If crockery is not perfectly dry, increase the dosage by turning the dial to a higher setting (5-6). Close the cover again. Rinse aid level indicator: Visual indicator: light dark = = add rinse aid sufficient rinse aid . [. . . ] Tighten the fixing nut by turning it clockwise. Make sure the nut is fully tightened (it should click). Make sure the spray arm rotates freely. Lower spray arm: 1. Press the two levers which fix the spray arm inwards (C), and detach by pulling it up (D). Remount the spray arm by aligning it with the rotor pin and insert it. [. . . ]