User manual WHIRLPOOL ADP 7955 WH SPACE PRODUCT FICHE

[. . . ] If required, select options (if supplied). Press the Start button to start the selected programme. Once set, the programmed data cannot be altered by turning the programme selector knob. Note: Once the Start button has been pressed, the dishwasher memorises the last programme selected. [. . . ] Note: If the dishwasher is switched off during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted. Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. To indicate the end of the programme, the Start indicator lamp switches off and the End indicator lamp (if fitted) lights up (for about 30 min. ). Turn the programme selector knob counter clockwise to its original position to switch off the dishwasher (only after the Start indicator lamp has switched off). Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. Close the water tap. Upper and lower rack Crockery holders: • Down: cups and long-stemmed glasses. Up: plates. Lower rack • A A Upper rack C “Flex ”: multi-purpose support • To be used, for example, for longhandled utensils (arrange knives with the blade facing downwards), cups and glasses. May be used in three different positions (see also “Dishwasher loading instructions” on Page 4). Upside-down, towards the centre of the rack. Upside-down, towards the left side. 3 Plate holders: • (A) may be lowered to increase available space. • 1. • Are the spray arms blocked or the nozzles clogged?(See “Care and Maintenance” chapter in the user instructions). • Is the lower spray arm correctly fitted?• Is the salt container cap (water softening system) screwed down?Marked crockery: • Is the water hardness level selector not properly adjusted?See (“Filling the salt container” in the user instructions). (See “Filling the salt container” in the user instructions). (See “Filling the detergent dispenser” in the user instructions). Marked glasses and cutlery: • Was too much rinse aid used?(See “Filling the rinse aid dispenser” in the user instructions). Note: with some models, when the Start button is pressed a pre-wash cycle precedes the actual wash programme; this regenerates the water softening system. AFTER-SALES SERVICE If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water supply tap, then call our After-Sales Service (see guarantee). [. . . ] • Do not use the appliance for items not suitable for washing in a dishwasher, for example: wooden items, aluminium, plastic utensils, tin, handdecorated crockery (unglazed), silver cutlery. • Do not put liquid fat in the dishwasher (e. g. • If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off. • If regeneration salt is to be added, immediately start a wash programme in order to eliminate any residual salt (rinsing alone is not sufficient). [. . . ]