User manual WHIRLPOOL ADP 8473 A 6S WH INSTRUCTION FOR USE

[. . . ] Quick reference guide Chart BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS! (see at right for options description) PROGRAM SELECTION BUTTON Push “P” button (repeatedly) until selected program number is shown on the display (P1. . . Px) - see “Table of programs” below. START/RESUME BUTTON Push this button to start the selected program: the indicator lights up and goes off at the end of the program. When the door is opened during a washing cycle, the cycle is temporarily paused: the Start indicator blinks. To resume the cycle close the door and push Start button again. CANCEL/OFF BUTTON Push this button to switch off the control panel. If pressed when a program is running it cancels the program ongoing draining water for 1 minute (0:01 is shown into the display). [. . . ] 200-400 mm from the lower edge of the appliance) - see Assembly instructions. Repeat without detergent or wait until foam disappears. The closure disk of the syphon hose connection must be removed. Error number “E”y - blinking Solutions. . . Check the household circuit fuse if there is no power supply. 0. 5 sec. pause . . . shows “F6 . . . shows “F6 E2” E7” or “F6 E1” - . . . shows “F6 E3”/wash program ended too early (dishes are dirty and wet) - . . . shows “F8 E1” - After taking the above course of action, the fault message must be reset. In the majority of cases the fault is thus eliminated. Water drains automatically for up to 1 minute. The appliance is now ready to be restarted. Possible causes. . . Too little space between dishes (incorrect arrangement of the concave items in the rack). T little detergent; detergent too old or incorrectly stored. oo T emperature not high enough for heavily soiled crockery. Loading of the dishwasher using lower and upper rack at the same time with “Half load/Multizone” option. Clogged spray arms, dirty filters or not fitted correctly. Spray arms stuck impeded by crockery or cutlery. . . . are not perfectly clean/have food residues Solutions. . . Arrange crockery so that items do not touch each other. bowls, cups) must be arranged facing downwards in the rack. If necessary, use more detergent, observing the manufacturer’s indications as regards dosage. Always store detergent in a dry place and do not store it for excessively long periods of time. For heavily soiled crockery, select a wash program with a higher temperature (see table of programs - page 1). If you select the “Half load/Multizone” option (if available), remember to load only the upper rack or only the lower rack to increase washing power and thus obtain optimum wash results. In the event of frequent use of the Eco 50°C program (if available), from time to time select the Intensive 65°C program (if available). The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see page 5, “Maintenance and care“). The spray arms must be able to turn freely and must not be impeded by crockery or cutlery. EN -6- What to do if. . . Crockery and cutlery. . . [. . . ] knives), must be placed in the cutlery basket with the sharp end facing downwards. Long-handled utensils must be arranged horizontally in the upper rack, with the sharp end facing away from the front of the appliance. The guarantee is not applicable if faults are caused by incorrect use of the appliance. - Before cleaning or carrying out maintenance, disconnect the mains plug and turn off the water tap; also in the event of any malfunction. [. . . ]