User manual WHIRLPOOL ADP 8942 AVM PROGRAM CHART

[. . . ] GB PROGRAMME CHART 6th SENSE: Optimum wash results coupled with maximum energy savings The two sensor-controlled programmes are recommended for routine washes. They use double sensor technology designed to ensure optimum wash results with minimum water and energy consumption. Rinse aid level indicator Add rinse aid. Half load button / Multizone Load the upper or lower rack only. [. . . ] Values may vary in relation to usage, e. g. : different loads, water temperatures, water hardness and power supply voltage. 5019 100 91157 (We reserve the right to make technical modifications) Quick Reference Guide Daily check list 1. Arrange crockery so that items do not touch each other. Load cups at an inclination to facilitate water circulation. In general, place the cutlery in the basket with the handles positioned downwards, but ensure that sharp knives and forks that might cause injury are placed in the basket with the handles positioned upwards. Make sure the water jet can reach all loaded items and that the spray arms rotate freely. Turn on the water supply tap before starting the dishwasher. GB Lower rack Upper rack Crockery holders: • Down: cups and long-stemmed glasses. • Up: plates. Half load button / Multizone: Loading the lower rack only: greater washing power, particularly for plates and saucepans. Important • Switch off the dishwasher once the “Start” indicator lamp has switched off. If the dishwasher is turned off during the washing programme, it will start again from the same point in the programme when it is turned back on. If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off!Refer to the “Troubleshooting Guide” in these user instructions to remedy any problems. Cutlery basket: The cutlery basket can be removed to increase available space. • Half load button / Multizone: If only the upper rack is to be loaded, remove the cutlery basket from the lower rach and place it in the upper one. Height adjustment: Glass holder: • The glass holder can be moved sideways. [. . . ] • The rack must be level on both sides. Plate holders: • The plate holders may be removed to increase available space. • To reposition: simply insert in the required position (normal or crosswise). • If a regeneration salt is to be added, IMMEDIATELY start a washing programme, in order to eliminate any residual salt. • Sometimes even when the regeneration salt container is full, the corresponding indicator lamp may illuminate during the first wash cycle. [. . . ]