User manual WHIRLPOOL ADP 995 WHM (6909) PROGRAM CHART

[. . . ] GB th ADP 995 PROGRAMME CHART 6 SENSE: Optimum wash results coupled with maximum energy savings The two sensor-controlled programmes are recommended for routine washes. They use double sensor technology designed to ensure optimum wash results with minimum water and energy consumption. Rinse aid level indicator Add rinse aid. Half Load button / Multizone Load the upper or lower rack only. [. . . ] Values may vary in relation to usage, e. g. : different loads, water temperatures, water hardness and power supply voltage. 5019 100 91169 (We reserve the right to make technical modifications) Quick Reference Guide Daily check list 1. Arrange crockery so that items do not touch each other. Load cups at an inclination to facilitate water circulation. Generally speaking, place cutlery in the basket with the handles positioned downwards, but ensure that any sharp knives and forks that might cause injury are placed in the basket with the handles positioned upwards. Make sure the water jet can reach all loaded items and that the spray arms rotate freely. Turn on the water supply tap before starting the dishwasher. GB Lower rack Upper rack Crockery holders: • Down: cups and long-stemmed glasses. • Raised: plates. Half Load button / Multizone: Cutlery holder for long utensils: • Raised: glass holder (gently lift up and release). • Down: large cutlery (gently lift up). • Place knives with blades facing downwards. Loading the lower rack only: greater washing power, especially for plates and saucepans. Important: • Switch off the dishwasher once the “Start” indicator lamp has switched off. If the dishwasher is turned off during the washing programme, it will start again from the same point in the programme when it is turned back on. If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off! [. . . ] • The rack must be level on both sides. Plate holders: • The plate holders may be removed to increase available space. • To reposition: simply insert in the required position (normal or crosswise). • If a regeneration salt is to be added, IMMEDIATELY start a washing programme, in order to eliminate any residual salt. • Sometimes even when the regeneration salt container is full, the corresponding indicator lamp may illuminate during the first wash scycle. [. . . ]