User manual WHIRLPOOL ADP7442WH

[. . . ] szep, hogy Quick reference guide Chart BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED. (see at right for options description) Options and display description SALT INDICATOR When lit (at the end of the cycle), the salt reservoir needs to be refilled. RINSE AID INDICATOR When lit (at the end of the cycle), the rinse aid dispenser needs to be refilled. PROGRAM SELECTION BUTTON Push “P” button (repeatedly) until selected program number is shown on the display (P1. . . Px) - see “Table of programs” below. START/RESUME BUTTON Push this button to start the selected program: the indicator lights up and goes off at the end of the program. [. . . ] - Press the START button. Switching off the appliance. After the program is completed appliance turns into Standby mode automatically. The water tap must be fully open during water inlet (minimum capacity: 0. 5 litres per minute). The water inlet hose must not be bent and the relative inlet filter in the water tap connector must not be dirty or clogged. bowls, cups) must be arranged facing downwards in the rack. The drain hose must be fitted correctly (for high mounted appliances, leave min. 200-400 mm from the lower edge of the appliance) - see Assembly instructions. Repeat without detergent or wait until foam disappears. The closure disk of the syphon hose connection must be removed. salt indicator is lit rinse aid indicator is lit . . . is not working/will not start . . . shows “F6 E7” or “F6 E1” or “H2O” - . . . shows “F6 E3”/wash program ended too early (dishes are dirty and wet) - . . . shows “F8 E1” - After taking the above course of action, the fault message must be reset. In the majority of cases the fault is thus eliminated. Water drains automatically for up to 1 minute. The appliance is now ready to be restarted. Possible causes. . . - Crockery and cutlery. . . . . . are not perfectly clean/have food residues - Solutions. . . Too little space between dishes (incorrect arrangement of the concave items in the rack). T little detergent; detergent too old or incorrectly stored. oo T emperature not high enough for heavily soiled crockery. Loading of the dishwasher using lower and upper rack at the same time with “Half load/Multizone” option. Clogged spray arms, dirty filters or not fitted correctly. Spray arms stuck impeded by crockery or cutlery. Arrange crockery so that items do not touch each other. bowls, cups) must be arranged facing downwards in the rack. If necessary, use more detergent, observing the manufacturer’s indications as regards dosage. Always store detergent in a dry place and do not store it for excessively long periods of time. [. . . ] knives), must be placed in the cutlery basket with the sharp end facing downwards. Long-handled utensils must be arranged horizontally in the upper rack, with the sharp end facing away from the front of the appliance. The guarantee is not applicable if faults are caused by incorrect use of the appliance. - Before cleaning or carrying out maintenance, disconnect the mains plug and turn off the water tap; also in the event of any malfunction. [. . . ]