User manual WHIRLPOOL ADPU 5300 WH PRODUCT FICHE

[. . . ] If “Fx Ey” messages appears on the display, see page 9 - chapter “What to do if. . . ”. RINSE AID INDICATOR When lit (at the end of the cycle), the rinse aid dispenser needs to be refilled. SALT INDICATOR When lit (at the end of the cycle), the salt reservoir needs to be refilled. 5019 396 03718 PROGRAM SELECTION BUTTON Push “P” button (repeatedly) until selected program number is shown on the display (P1. . . Px) - see “Table of programs” below. DELAYED START BUTTON Push the button (repeatedly) to delay the start of the program delay indicator turns on. With each press of the button, the delay increases by one hour and after "h 24" returns to "h 00”. [. . . ] Duration of the program depends on the external conditions in the apartment, temperature and pressure etc. Wash cycle The dishwasher door must be closed and the water tap open. if you want to insert an item): - Open the door with caution (the program pauses) and insert the item/s, (beware of HOT steam!). - Close the door and press the START button again to restart the cycle (the program resumes the cycle from where it was interrupted). To Cancel the program on running: - Press the CANCEL/Off button. - (Water drains for up to 1 minute then the appliance switches off). To change the program in progress: - Press the CANCEL/Off button to cancel the program on running. - (Water drains for up to 1 minute then the appliance switches off). - Press any button except CANCEL/Off button to switch on the appliance. - Press the START button. Switching off the appliance. Everything OK. . . After the program is completed appliance turns into Standby mode automatically. Exercise caution when opening the door: beware of hot steam. - Clean dishes left in dishwasher for a long time after end of cycle (e. g. when using “Delayed start” option). - Incorrect arrangement of the concave items in the rack. - In the event of frequent use of the Eco 50°C program (if available), from time to time select the Intensive 70°C program (if available). - The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see page 8, “Maintenance and care“). - The spray arms must be able to turn freely and must not be impeded by crockery or cutlery. - Set “Tablet” option; if this option is not available, it is normal for the salt indicator to light up. - In areas with very hard water, more regeneration salt needs to be added (see page 3, “How to set water hardness”). - Close the salt reservoir cap properly. - If you use a combined action detergent, try adding more rinse aid. - Synthetic materials do not dry well; if wet at end of cycle, wipe dry. [. . . ] - Do not use solvents inside the dishwasher: risk of explosion!- Be careful when the door is open: risk of tripping!- The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it. [. . . ]