User manual WHIRLPOOL AFG 8101/1 INSTRUCTION FOR USE

[. . . ] Any damage must be reported to your dealer within 24 hours after delivery of the appliance. 2. Wait at least two hours before switching the appliance 1. Red LED (if provided): indicates that the appliance temperature is not sufficiently low. 3. Green LED (if provided): indicates that the appliance on in order to ensure the refrigerant circuit is fully efficient. [. . . ] Classification of frozen foods Put the frozen MONTHS FOOD products into the appliance and classify them; The storage date should be indicated on the packs, to allow use within expiry dates. Advice for storing frozen food When purchasing frozen food products: • Ensure that the packaging is not damaged (frozen food in damaged packaging may have deteriorated). If the package is swollen or has damp patches, it may not have been stored under optimal conditions and defrosting may have already begun. transport the products in a thermally insulated cool bag. • Once at home, place the frozen foods immediately in the appliance. • Avoid, or reduce temperature variations to the minimum. Respect the best-before date on the package. • Always observe the storage information on the package. Note: Eat fully or partially defrosted foods immediately. Do not refreeze unless the food is cooked after it has thawed. Once cooked, the thawed food can be refrozen. If there is a long power failure: • Do not open the appliance lid except to place ice packs (if provided) over the frozen foods on the right and left of the appliance. This will slow down the rise in temperature. GB PRECAUTIONS AND GENERAL RECOMMENDATIONS INSTRUCTIONS FOR USE • Place a bowl beneath the 3. The green LED (if provided) is off and the appliance is not working. • After installation, make sure that the appliance is not • Is there a power failure?• Is the plug properly inserted in the socket?• Do not store glass containers with liquids in the appliance • • Is the electric cable intact?(See chapter preferable not to switch it off. “Installation”) Do not use abrasive products, scourers or • Be careful not to damage the floors when you move the stain-removers (e. g. Formation of condensate on the external walls of the appliance (e. g. • Do not use mechanical devices or any means other than those recommended by the manufacturer to speed up the To obtain the best results from your appliance, carry • It is normal for condensation to form under certain out cleaning and maintenance at least once a year. atmospheric conditions (humidity above 85%) or if the • Do not use electrical appliances inside the product, unless CHANGING THE LID appliance is located in a damp or poorly ventilated room. such appliances are specifically recommended by the LIGHT BULB The performance of the appliance is in no way affected. The layer of ice on the internal walls of the appliance • This appliance is not designed for use by young children or • Disconnect the appliance from is not uniform. • To avoid the risk of children being trapped and therefore • This phenomenon is quite normal. • Remove the diffuser by suffocating, do not allow them to play or hide inside the SAFEGUARDING THE ENVIRONMENT following the sequence of steps appliance. Packing • The power cable may only be replaced by an authorized • Unscrew the light bulb and The packaging material is entirely recyclable, and marked with person. replace it with an identical bulb of the same wattage and the recycling symbol. [. . . ] DEFROSTING THE APPLIANCE The appliance should be defrosted when the thickness of ice • Are the ventilation grille and condenser clean?AFTER-SALES SERVICE on the walls reaches 5-6 mm. Before contacting After-Sales Service: • Disconnect the appliance from the mains power supply. • Is the appliance perfectly horizontal? [. . . ]