User manual WHIRLPOOL AFG 8244 NF UP FR INSTRUCTION FOR USE

[. . . ] To cancel or to change the previously set time turn programme selector knob to “0” or open the door. TRKK6850 Programme selection Drying options Buzzer & Anti-Crease cannot be selected together Fabric programmes & Drying levels Dryness Gentle Adjustment Reduces (Adjusts Dryness drying Level according intensity to wishes) (recommended for delicate items) Buzzer Signals/ Sounds end of drying cycle at Intervals Anti-Crease Prevents laundry from creasing Start Delay Delays the drying cycle start Start delay 95’ 135’ 80’ 110’ 60’ 90’ 50’ 70’ 20’ 35’ 15’ 25’ 3. 5 Ready to wear Cotton Cupboard dry * Cotton 80’ 110’ 60’ 90’ max 5 kg Iron dry * Remaining time After cycle start a default drying time is indicated depending on the selected indication drying programme and the dryness adjustment. After several minutes the time will be adjusted to the real expected remaining time, depending on size, type and humidity of the load. [. . . ] The indicator lamp lights up when the filter needs cleaning. Clean the filter at the end of every cycle. Lights up when water container needs to be emptied. Press the Start/Pause button to restart the dryer and to continue the programme. 5 kg Airing - - - Airing Laundry is aired and refreshed for 30 minutes without heating. Completes drying or dries single items (suitable for all fabrics). Time PROGRAMME SEQUENCE INDICATION The programme sequence is indicated by lamps, switching on when programme step starts and switching off when the programme step is passed. * Test programmes according IEC 61121 5019 407 00099 PREPARING THE LAUNDRY 1. Check that all fastenings are closed and that pockets are empty. Place laundry loosely in the drum to make sure it doesn’t become tangled. Sort laundry as follows: A) By care symbols (on the collar or inside seam): Suitable for tumble drying Tumble drying with reduced drying intensity only. CHANGING A PROGRAMME When changing the programme during the drying cycle, the dryer stops. the Start/ Pause indicator lamp is blinking. To operate the new programme, press the Start/Pause button. INTERRUPTING A PROGRAMME To interrupt the dryer during operation 1. Wait at least 5 minutes before opening the door to allow the dryer to cool down. For your safety the programme stops automatically if you open the door. To restart, after door opening, close the door and press the Start/Pause button again. DAILY MAINTENANCE & CLEANING Clean the lint filter at the end of every drying cycle: 1. Remove lint using a soft brush or your fingertips. Empty the water container at the end of every drying cycle. Pull the handle to remove the water container. [. . . ] € Is the lint filter dirty (filter indicator lamp on)?€ Is the heat exchanger dirty (refer to the Instructions for use)?The dryer does not operate: (after a power failure and/or interruption to the mains supply, always press the Start/Pause button). € Is the plug properly inserted into the mains electricity socket? [. . . ]