User manual WHIRLPOOL AGB 022 INSTRUCTION FOR USE

[. . . ] − Place the ice maker on a stable, level surface and adjust the feet if necessary. − Do not install the unit close to a heat source, in a niche, or leaning against a wall on one side; air must be free to circulate through the ventilation grids (vicinity not less than 6 cm). − In rooms with an ambient temperature lower than +10oC or higher than +32oC, ice cubes production is not guaranteed. However, at ambient temperatures from +16oC to +32oC, ice cubes production can be guaranteed if a tropicalized unit is installed. 4 GREEN AND YELLOW (“E”) BROWN (“L”) CABLE CLAMP. BLUE (“N”) Connection to a typical 13 amp plug ELECTRICAL CONNECTION Check that the voltage on the rating plate corresponds to the voltage in your home (Fig. [. . . ] 8) Drain the water and repeat the operation, by rinsing with 1. 5 l of water and leaving the appliance operating for 5 minutes. 9) Remove the funnel with the hose after the water drain and replace the plug or the drain hose. 10) Clean the inside of the bin reservoir and the door gasket with a soft cloth dampened in a solution of warm water and baking soda. 11) Press the green switch and turn the water on: the ice maker will begin to work again. − We recommend you ask the intervention of a qualified technicien to clean periodically (once a year) the condenser and the motor compartment. Important: To prevent odour contamination of the ice cubes, do not put foods or beverages into the ice cube bin. When not in use for long periods of time (holidays, etc. ) turn off the water, pull out the plug, remove all ice cubes, drain the water tank by removing the plug or the drain hose (Fig. 8), and leave the door open to prevent the formation of odours. STARTING UP Before using your ice maker for the first time, clean it thoroughly. Follow the instructions in the “Maintenance” section of this booklet. − Plug the appliance into the wall socket. − Press the green switch. ADJUSTING THE ICE CUBE THICKNESS Ice cube thickness is pre-set at the factory. The thickness can be increased or decreased by turning the thermostat knob with a screwdriver. Turning the knob clockwise increases the thickness, turning it anti-clockwise decreases the thickness (Fig. By means of the thermostat knob it is possible to adjust the variations due to the ambient temperature, when it is higher than 32oC and lower than 10oC. − Never turn the thermostat knob outside the field indicated on the dial. − Adjust the ice thickness thermostat only after a few hours operation and only after the bin has half-filled with ice cubes. − Non-observance of the thermostat setting rule could result in damage to the ice maker, especially if the thermostat knob is left on a low setting in high room temperature. In this case the ice could become so thick that the ice will not be cut. On the other hand, the ice thickness could be reduced to a minimum or none at all. SERVICE If the ice maker does not work properly or does not work at all, before calling for service, carry out the following checks (which are also listed on the sticker at the back of the appliance Fig. This is very important as travel expenses and labour costs will be charged to you if your call turns out to be unjustified. If the compressor does not work and the ice bin is empty, check that: − There is power at the outlet. − the plug is connected correctly to the socket − one of the power cord wires is not disconnected. [. . . ] 7) Pour 1. 5 l water and 2 tablespoonful of baking soda into the bin, press the two switches (green and blue) and operate the appliance for 5 minutes approx. REPLACEMENT OF THE SUPPLY CORD If the replacement of the supply cord is required, please buy a similar supply cord by one of our service centres. How to operate: 1) Disconnect the supply cord from the mains supply. Unscrew the two rear screws and slide the top frontwards to disengage it from the front seats. 3) Release the supply cord from the clamp (Fig. [. . . ]