User manual WHIRLPOOL AGB 278/WP INSTRUCTION FOR USE

[. . . ] Introduction Safety preacutions Manufacturer’s liability Machine starting Operating instructions Operating instructions ICD tilting operating instructions Pausa and stop Single cycle Memorised programs Programing Programing for coin op machines Alarms General maintance 9 9 9 9 10 10 10 10 10 11 11 12 13 13 INDEX 1. INTRODUCTION This manual includes all the specifications necessary for a safe and correct use of dryers. Installation and maintenance of machines must be performed by authorised and qualified technicians; they have to know our products and be acquainted with European standards for installation of industrial laundry equipment. This manual is for installer’s and technician’s use; they have to read and understand it carefully before installing, using or servicing the machine. [. . . ] €: put into the wished time (29 and 90°C) and confirm with ENTER. MEMORISED PROGRAMS herewith the characteristics of the builder implemented programs. The cooling time is equal to 10 minutes and the cooling temperature is equal to 30°C for all the programs. PROGRAMMING The characteristics of the ten programs in the memory can be modified proceeding as follow Press the buttons “UP” and “DOWN” at the same time while the display shows “SELECT A PROGRAM”. Appears “INSTALATION”: With the buttons “UP” and “DOWN” is possible to defoliate the parameters and to go out from the programming system, keeping the modification done, with the button “STOP” many times up to the display shows “SELECT A PROGRAM” The parameters modifiable are: LANGUAGE Press “ENTER” in order to modify the parameter. Press the buttons “UP” and “DOWN” to modify the language seeing the possibilities. chosen the language press “ENTER” to confirm. INFORMATION Press “ENTER” in order to modify the parameter. appears “WORKING HOURS”. Press again the buttons “ENTER”: in the display appears the hours accumulated since the date of installation of the machine. To go out from the parameter press “ENTER”. And “DOWN” to change the language seeing the possibilities. chose the language and press “ENTER”. DATE (only for ICD model) Press “ENTER” in order to modify the parameter. Change the value using the alphabetical keyboard 12 E020401CW 26/11/04 and press “ENTER” to confirm HOURS (only for ICD model) Press “ENTER” in order to modify the parameter. Change the value using the alphabetical keyboard and press “ENTER” to confirm PROGRAMME Press “ENTER” to change the characteristic of one or more program. Appears “50 min 90°C” which is the first program. Pressing the buttons “UP” and “DOWN” is possible to defoliate the parameters, when appears the program you would like to modify press “ENTER” in order to enter in a menu of parameters of the chosen program. NAME Press “ENTER” in order to enter in the parameter. Insert the name chosen using the alphabetical keyboard. Use the bottom “SINGLE CYCLE” to delete any mistakes and press “ENTER” to confirm and go on to the next step. AUTO (only for machine equipped with the humidity sensor) Press “ENTER” in order to visualize the parameter. [. . . ] If the warning still appear, switch off the machine, disconnected the alimentation and call our technical assistance OPEN DOOR The door is open. Close the door and press START to activate the program or STOP to interrupt it. If the alarm rings again, turn off the machine, take off all connections and call for assistance. OPEN FILTER The filter box is not closet correctly. [. . . ]