User manual WHIRLPOOL AGB 508/WP INSTRUCTION FOR USE

[. . . ] • Fit the legs to the appliance; the appliance must be levelled using a spirit level. Slight irregularities can be levelled by adjusting the feet themselves. With table models, make sure that the base chosen is capable of supporting the weight of the appliance. [. . . ] The earth lead must be a little longerthan the others so that it is the last lead to disconnect if the wire clamp breaks. 4. 2. 2 Unipotential RETRO BACK ARRIERE RÜCKSEITE • The appliance must be connected up to a unipotential system. The connection screw is located on all top models at the back on the right hand side, while in other models it is located underneath the appliance on the right hand side. • The manufacturers cannot be held responsible for any damage due to inadequate or incorrect installation. Under such circumstances the guarantee will be considered null and void. 4. 2. 3 Start-up • Before using the appliance for the first time, thoroughly clean the tank (see “Cleaning and Taking Care of the Appliance”) to remove the protective film of mineral oil applied in the factory. • Check installation and wiring, then turn the appliance on following the instructions below, and leave on, empty, for about 15 mins. 4. 2 Legal and technical requisites When installing the appliance, the following safety standards must be adhered to: - Local accident prevention standards - Current CEI standards. 066_03 - Electric tilting cooker 07/2007 6 · 10 5 - SET-UP FOR OPERATION Warning!- Beware of inexpert handling! 5. 3 What to do if not using the appliance for a long time • Thoroughly clean and dry the machine as described. • After cleaning, we recommend you grease the pan with vegetable oil. 5. 1 Ignition • Check that the overflow is in place. Turn on the main switch upstream of the appliance. Turn the thermostat to any position between 50°C and 300°C; the pilot lights will come on; the green one shows that the appliance is on, the yellow one shows that the resistances are on. As soon as the required temperature is reached, the yellow light goes off. • To turn the appliance off, simply turn the knob back to '0'. 5. 4 What to do if something goes wrong • If anything goes wrong, immediately turn the appliance off, then turn off the power supply at the switch located upstream of the appliance, and call the aftersales department. 5. 2 Taking care of the appliance - Frequency of maintenance 5. 5 MAINTENANCE Attention!Never clean the appliance with jets of water, whether direct or pressurised. Allow the machine to cool down before cleaning • Giving the appliance a thorough clean every day (after turning it off) will keep it in perfect working order and make it last longer. • All steel parts should be cleaned with water and a detergent, using a damp cloth; do not use abrasive substances or corroding detergents. • Do not use steel wool, which could leave traces of rust. For the same reason, avoid touching the appliance with anything made of iron. • Do not clean any parts of the appliance other than the grilling plate with emery or sandpaper. If absolutely necessary, you may use powdered pumice stone. [. . . ] Failure to do so shall result in the user being subject to the penalties prescribed by the legislation in force on waste. Suitable separated collection so that the unit no longer used can be sent off for environmentally compatible recycling, treatment and disposal helps avoid possible negative effects on the environment and on health and facilitates the recycling of the product's component materials. For more detailed information on available collection systems, contact the local waste disposal service or the shop you purchased the unit from. [. . . ]