User manual WHIRLPOOL AGB 514/WP INSTRUCTION FOR USE

[. . . ] READ THE INSTRUCTION MANUALS BEFORE INSTALLING AND USING THE APPLIANCE. THE APPLIANCE MUST BE INSTALLED BY QUALIFIED PERSONNEL. FRYER Model AGB 597/WP AGB 521/WP AGB 515/WP AGB 598/WP AGB 523/WP AGB 516/WP Dim. : LxWxH 400 x 615 x 300 400 x 700 x 875 400 x 700 x 300 600 x 615 x 300 600 x 700 x 875 600 x 700 x 300 400 x 615 x 300 AGB 522/WP AGB 514/WP AGB 524/WP AGB 525/WP 400 x 700 x 875 400 x 700 x 300 400 x 700 x 875 800 x 700 x 875 Voltage rating 230 V 3 AC or 400 V 3N AC 230 V 3 AC or 400 V 3N AC 230 V 3 AC or 400 V 3N AC 230 V 3 AC or 400 V 3N AC 230 V 3 AC or 400 V 3N AC 230 V 3 AC or 400 V 3N AC 230 V 3 AC or 400 V 3N AC 230 V 3 AC or 400 V 3N AC 230 V 3 AC or 400 V 3N AC 230 V 3 AC or 400 V 3N AC 230 V 3 AC or 400 V 3N AC Power 7. 5 kW 7. 5 kW 7. 5 kW 15. 0 kW 15. 0 kW 15. 0 kW 6. 2 kW 6. 2 kW 6. 2 kW 12. 0 kW 24. 0 kW Lead wire / Section 4 x 2. 5 mm2 or 5 x 1. 5 mm2 4 x 2. 5 mm2 or 5 x 1. 5 mm2 4 x 2. 5 mm2 or 5 x 1. 5 mm2 4 x 6 mm2 or 5 x 2. 5 mm2 4 x 6 mm2 or 5 x 2. 5 mm2 4 x 6 mm2 or 5 x 2. 5 mm2 4 x 2. 5 mm2 or 5 x 1. 5 mm2 4 x 2. 5 mm2 or 5 x 1. 5 mm2 4 x 2. 5 mm2 or 5 x 1. 5 mm2 4 x 6 mm2 or 5 x 2. 5 mm2 4 x 10 mm2 or 5 x 6 mm2 005- 03 - Electric fryer 4 INSTALLATION INSTRUCTIONS Before beginning installation, remove all packaging from the appliance. Some parts are protected with an adhesive film which should be carefully removed. Any remnants of glue should be thoroughly cleaned using suitable substances such as benzine. [. . . ] The earth lead must be a little longerthan the others so 1 RETRO BACK that it is the last lead to disconnect if the wire clamp ARRIERE RÜCKSEITE breaks. Unipotential The appliance must be connected up to a unipotential system. The connection screw is located on all top models at the back on the right hand side, while in other models it is located underneath the appliance on the right hand side. Warning! The manufacturers cannot be held responsible for any With Top models, carefully measure the distance damage due to inadequate or incorrect installation. between the appliance and the edge of the base (Fig. Under such circumstances the guarantee will be considered null and void. Legal and technical requisites When installing the appliance, the following safety stan- Start-up dards must be adhered to: Before using the appliance for the first time, thoroughly clean out the oil bath (see paragraph entitled “Cleaning - Local accident prevention standards and Taking Care of the Appliance”). Check that the appliance is connected up properly and - Current CEI standards. start according to instructions overleaf. 005- 03 - Electric fryer 5 USING THE APPLIANCE Warning! - Beware of inexpert handling!- Old and dirty oil or frying fat can represent a real fire hazard; make sure only new oil or frying fat are used each time you start frying. - The food you intend to fry should always be dry; wet food causes the oil to foam and overflow. - Frying excessively large quantities of food at a time also causes the oil to foam; never exceed 1. 5 kg. - If the level of oil in the bath falls below the low level mark stamped on it, the risk of fire will increase. - Never leave the appliance on without any oil in it. The lid delivered with the appliance should always be kept within easy reach. In case of fire, it should be used to douse the flames. CLEANING AND TAKING CARE OF THE MACHINE Warning! Never clean the appliance with jets of water, whether direct or pressurised. Allow the machine to cool down before cleaning Before starting to clean the appliance, disconnect from the mains. Using the hook provided (see drawing 3), you can lift out the elements to make cleaning the appliance easier and far more thorough. Lift the elements as far as they will go. To lower them after cleaning, press the button on the left hand side. All steel parts should be washed in warm water, using a neutral detergent, then rinsed thoroughly to eliminate any residual detergent. Avoid using abrasive or corrosive detergents which Ignition Check that the oil drain release is closed. [. . . ] appliance. Important With Top models, make sure you respect the distance between the appliance and the edge of the base. 2 3 MAX 120 mm 005- 03 - Electric fryer 6 THE 2002/96/EC DIRECTIVE (WEEE): information to users This informational note is meant only for owners of equipment marked with the symbol shown in Fig. A on the adhesive label featuring the technical specifications applied on the actual product (the label also giving the serial number). This symbol indicates that the product is classified, according to the regulations in force, as an item of electrical and electronic equipment and conforms to EU Directive 2002/96/EC (WEEE) meaning that, at the end of its service life, it must be treated separately from domestic waste, i. e. it must be handed in free of charge to a separate waste electrical and electronic equipment collection centre or returned to the reseller when buying a new equivalent item of equipment. [. . . ]