User manual WHIRLPOOL AGB 581/WP INSTRUCTION FOR USE

[. . . ] 18/10 chrome-nickel steel outer panelling. Assembly, installation and maintenance, i. e. : - assembly, connecting the gas supply, checking power rating, transforming or adapting the appliance to run on other types of gas, and commissioning, - connecting the appliance to the mains, must all be done by contractors authorised by the local Gas and Electricity Boards in accordance with local and national legislation. Before doing anything else, seek advice from your Gas and Electricity Boards. Cooking top (Gas) - Each position has a burner with a flame distributor. - Each position has independent piezo ignition. [. . . ] It is normally enough, however, simply to check that the nozzles are functioning correctly. - Start the appliance in accordance with the instructions; - Check the gas tubes for leaks; - Check that the flame on the main burner lights properly and is correctly formed, even on low; - Draw up a servicing and maintenance contract. Note for the installer - Explain and demonstrate to the user how the machine works according to the instructions, and hand him this manual. - Remind the user that any structural alterations to the room housing the appliance may affect the combustion air supply. Once the alterations have been completed, the appliance and its functions should be thoroughly checked. Checking input pressure (Fig. 2) Input pressure should be measured using a gauge (e. g. Remove screw (F) from the pressure socket and connect it to the tube on the gauge; after measuring, the screw should be retightened absolutely airtight (F). Running the appliance on other types of gas When changing to another type of gas, e. g. from natural to LP, or to another gas group, consult the “TECHNICAL DATA” table 1 to make sure you use the appropriate nozzlzes for the main burner. The nozzles for the cooking top burners for different types of gas, marked in 100ths of mm, are in a case supplied with the appliance. When the appliance has been transformed or adapted, recheck its functions as described in paragraph "Checking the functions", page 7. Checking power rating using the volumetric method Using a gas meter and a chronometer, you can read the volume of gas output per time unit. The correct volume will be the value of “E” expressed in litres per hour (It/hr) or litres per minute (It/min). The following formula is used to calculate the value of “E”: Replacing the nozzle on a burner (Fig. 2) To change nozzle (C), remove the knobs and loosen the control panel fixing screws. If the main burner needs cleaning, proceed as follows: a) remove the pan support, the flame distributor, the crown and the burner supports; b) clean the parts with water and detergent, rinse and dry; c) when reassembling the parts, make sure you replace them in the right order. WARNING Every time a replacement involving gas input parts is made, recheck all functions and test for leakage. Resistances electric oven 60 Disconnect the power supply!Open the oven door; remove the protective shield covering the back wall of the oven by loosening its fixing screws; the resistance is held by 5 screws, two of which are on the flange. Once these screws have been loosened, you can pull the resistance forward. Disconnect the leads and fit a new resistance. Resistances electric oven 90 Disconnect the appliance from the mains. The bottom resistance is under the oven floor. The top resistance is fixed to the roof of the cooking chamber. To remove the resistances, loosen the screws fixing them to the relative flange, pull the resistances and relative leads forwards. Disconnect the leads using a screwdriver and fit a new resistance following the above sequence in reverse order. 008- 03 - Gas cooker 8 Validity from serial number 0627005545 2 C E D F 008- 03 - Gas cooker 9 Validity from serial number 0627005545 USING THE APPLIANCE START-UP Turning the electric oven on and off 90 (Fig. 6) Turning a burner on and off (cooking Select the type of heating required by turning knob 23, bearing in mind that the indicator light 25 stays on in all top) (Fig. 2) Press the knob (H) and turn to the left as far as . [. . . ] Do not use steel wool, which could leave traces of rust. For the same reason, avoid touching the appliance with anything made of iron. Do not clean any parts of the appliance other than the grilling plate with emery or sandpaper. If absolutely necessary, you may use powdered pumice stone. [. . . ]