User manual WHIRLPOOL AGB 626/WP INSTRUCTION FOR USE

[. . . ] Before doing anything else, seek advice from your Gas and Electricity Board. 1) INSTALLATION PROCEDURE la) Location : When thè appliance has been removed from its boxing, peel off thè parts of adhesive plastic film that protect thè steel parts . Thè glue residuate must be removed accurately ( do not use abrasive products ). Thè appliance should be installed in a well ventilated room, under a range hood to avoid harmful concentration of smokes and combustion gas dangerous for thè health. [. . . ] Consider also if other gas appliances are or have to be connected to thè same gas supply. 2b) Checking thè primary air Protection against thè flame rising when thè burner is cold or light-back when is hot. thè flame has to be blue without yellow tongues. 2c) Checking the functions Push the hand knob and turn it counter-dockwise to thè position. Keep thè knob pressed and check thè lighting of thè burner by looking through thè hole in thè control panel. When thè burner is lighted turn thè knob on MAX position. to unlit thè burner turn the knob clockwise to position O. 2e) Regulation of smaliflame : Turn on thè main burner according to the instructions, turn the knob at the position MIN of thelittle flame. Make sure that, at thè position MIN, burner's flame is stili alight, even during rapid turning of thè knob from thè MAX to thè MIN. In case that at thè position MIN, burner's flame dies down, or if thè flame is very strong then do the following steps: - Keep thè knob at thè position MIN - Pull off the knob of the tap and with a small screwdriver regulate thè screw of thè tap, which is located behind thè hole - When you turn thè bolt right you reduce the intensity of thè flame, and when you turn it left you make the flame stronger. - Regulate thè intensity of thè flame at your will. Then put back thè black knob of thè tap at its former position. 2f) Running thè appliance on other types of gas appliance is supplied with a kit of nozzles marked with thè diameter of their holes ; each plastic bag contains thè set of nozzles and shows the name of the gas. 12 2g) Replacing thè nozzles Put thè appliance upside down and loosen the screws of the panel, take out thè finned cover of thecombustion chamber, loosen the screws of the burners support. With a proper spanner, unscrew the nozzle and replace it with the correct one. After fitting the nozzle, before screwing back the panel, turn the appliance and verify the correct combustion and reset thè primary air. Warning : After setting the appliance for another type of gas indicate the modifìcation in the technical data label. 3) SPECIAL MANTAINANCE Before doing anything else disconnect the appliance and dose the gas valve. [. . . ] The control panel and the knobs must be cleaned with a soft humid cloth. The plates must be carefully cleaned with a steel brush or a steel wool. Is advisable to clean the lukewarm plates and to keep them shining is advisable to use vinegar. After cleaning and rising the plates spread a thin coat of oil prevent rust from forming. [. . . ]