User manual WHIRLPOOL AGB 674/WP INSTRUCTION FOR USE

[. . . ] DISCARD THIS PRODUCT IN CONFORMITY TO THE LOCAL NORMS REGARDING WASTE DISPOSAL. FOR MORE INFORMATION REGARDING THE TREATMENT, SALVAGE AND RECYCLING OF THIS PRODUCT, CONTACT YOUR COMPETENT LOCAL OFFICES, YOUR LOCAL WASTE COLLECTION SERVICE PROVIDER OR THE POINT OF SALE IN WHICH THE PRODUCT WAS PURCHASED. DO NOT INSERT SOLVENTS SUCH AS ALCOHOL OR TURPENTINE INTO THE MACHINE, AS THEY COULD CAUSE AN EXPLOSION. DO NOT INSERT DISHES WITH ASH, WAX OR VARNISH RESIDUES INTO THE MACHINE. [. . . ] The electrical terminal strip for making connections to the dosing units is located inside the electrical box. The terminals (B) and (D) on the terminal strip are for the dosing connections: (B) for the brightener and (D) for the detergent. Do not pour detergent directly into the tubs; this will cause dark marks to appear on their surfaces. The brightening equipment (B) operates on 24V, and the detergent equipment (D) operates on the mains voltage. The machine equipped with a IPX1 degree of protection and should therefore not be washed using direct jets of water. 4. 1 WATER CONNECTIONS: The machine has a filter whose inlet, install a maintenance and safety valve in an easily accessible position upstream. The water temperature should be between 50°and 55°C; the pressure should be between 200/400 kPa and the water hardness should be between 7° and 12° French. Hold down the button located next to the thermostat and fill the boiler with water. When the boiler is completely full, water will issue from the rinsing nozzles. Be careful here, because if you let it get to high you could burn out the electrical. With machines that have a steam-condenser and heat energy-recovery capability, cold water must be feeding at a temperature of between 10° and 15°C. 4. 2 DRAIN WATER: Install a floor-level discharging siphon connected to the discharge drain. If no siphon is provided, install one soas to avoid fumes. Make sure that the discharge tube can resist a temperature of 70°C and no kinks in it. 4. 3 STEAM FEEDING: Connect to the machine fittings as shown in the installation drawing. Install quick-closing and shit-off valves to make the equipment independent from the main line. The steam should be supplied, saturated and dry, at pressures ranging between a minimum of 0. 5 bar (50Kpa-110. 8°C) and a maximum of 0. 8 bar (80Kpa-110. 8°C) 4. 4 STEAM DRAIN: The condensed steam discharge line to the recovery system has to have an adequate slope to provide positive evacuation. A maintenance quick closing valve should be installed in parallel with the condensate discharge, so as to be able to deviate the condensate to the sewer. Caution: make sure that the supply and drain tubes are not bent, restricted or crushed after installation. 4. 5 Electrical connection The dishwasher’s electrical connection, and that of eventual supplementary apparatus, is to be entrusted to authorized and qualified personnel, with respect to the norms in vigor; the technical regulations for the connections are also to be observed. The total power installed is given upon the apparatus’ technical data label. Other apparatus must not be protected together with the dishwasher. The user must provide for the installation, according to the norms in vigor, of a main electrical power switch and of a differential switch compatible with the machine’s characteristics. [. . . ] In order to keep the machine in good running order, any hard-water deposits (calcium and magnesium carbonates, etc. ) should be periodically removed by qualified professionals. In order to avoid drops or vapors damaging the steel surfaces, do not even use the above-indicated products for the cleaning of the flooring beneath or around the dishwasher. 7. 2 Periodic checks Disassemble the wash and rinse arms (lower and upper). Clean the holes and the nozzles under a stream of clean water. Do not use utensils which could cause damage. [. . . ]