User manual WHIRLPOOL AGS 194/WP INSTRUCTION FOR USE

[. . . ] Please read this booklet carefully as it contains important information concerning safe installation, use and maintenance. Please keep this booklet in a safe place for further consultation by other operators. The appliance must be installed by a trained technician in accordance with the manufacturer’s instructions. The appliance must only be used by trained personnel. [. . . ] The symbol “weee” on the product indicates that this product should not be treated as domestic waste, but must be correctly disposed of in order to prevent possible negative consequences for the environment and the human health. Regarding the recycling of this product, please contact the sales agent or dealer of your product, your after-sales service or the appropriate waste disposal service. The dismantling of the appliance must be do in any case by qualified personnel. 6 – INSTRUCTIONS FOR USE CARE AND ROUTINE MAINTENANCE Routine maintenance operations can be carried out by non-specialized personnel, carefully following the instructions given below. The manufacturer declines all liability for any operations carried out on the appliance without respecting these rules. PRECAUTIONS IN CASE OF LONG IDLE PERIODS During long idle periods, take the following precautions: - Unplug the appliance - Go over all the stainless-steel surfaces vigorously with a cloth moistended with paraffin oil in order to form a protective film -Periodically air the room 5 – INSTRUCTIONS FOR INSTALLATION PLACE OF INSTALLATION The appliance must only be installed in adequately ventilated premis. REFERENCE STANDARDS Install the appliance according to the prescriptions of current safety standards. In any case, this appliance was produced in conformity of the following european directivities: -DIRECTIVE 92/59/EEC Leg. Decree 115/95 concerning the general safety of products. POSITIONING Unpack the appliance and carefully remove the protective film from the outer panels to avoid leaving any trace of adhesive. Use a suitable solvent to remove any adhesive residues. Dispose of the packaging as instructed in the chapter on “Disposal”. Refer to the installation diagrams at the beginning of this booklet for the space requirements and connection dimensions of the appliance. The appliance is not suitable for built-in installation. Set the appliance and if neccessary adjust the work height with the adjustables feet. SPECIAL MAINTENANCE Special maintenance must be carried out by trained personnel. GB – The manufacturer reserves the right to modify the appliances presented in this pubblication without notice. For further information regarding your model, please refer to the "Technical Data" table. _Range of single or double-opening ambient and hot cupboard counters with sliding or leaf doors. _Range of sinks with sliding or leaf-door cupboards for inserting a dishwasher. _Range of sliding-door crockery storage cabinets. Information on noise levels: The functional components of the equipment in question have a noise level not exceeding 70 dB(A). [. . . ] TS on page 6 OPERATION CHECK Switch the equipment on as described in the section “instructions for use”. Explain operation and routine maintenance procedures to the user, with the aid of this handbook. During operation pay attention to the hot zones on the exterior surface. Do not cover or obstruct any drains present. [. . . ]