User manual WHIRLPOOL AGS 405/WP INSTRUCTION FOR USE

[. . . ] The hood must be positioned according to the following parameters: it must be connected to an efficient flue directly to the outside, of adequate size for the hood’s extraction capacity. The recommended height from the floor is 1900/2000 mm; the perimeter of the hood must protrude by at least 20 cm with respect to the area of the appliances, and in any case that value must comply with current local regulations. Make sure the ceiling or wall can take the weight of the hood; otherwise have the necessary masonry reinforcement work carried out. HOOD INSTALLATION The hood can be installed using the plugs and eyebolts supplied. [. . . ] Where the appliance has stainless steel components, remove the protective film very slowly, without tearing, to avoid leaving traces of adhesive. Appliances must be moved using a fork lift trolley. Insert the forks under the pallet and move the appliance to the site of installation taking care that the load is properly balanced. Caution: To avoid tipping the appliance over, do not push or pull it during transport. Disposing of packaging Packaging material must be disposed of in conformity with current local safety regulations. Plastic packaging materials that can be recycled are labelled as follows: polyethylene: outer protective film, bag PE instructions polypropylene: straps PP expanded polystyrene: corner protectors PS compressed cardboard: corner protectors Caution: PUT ON PROTECTIVE GLOVES BEFORE BEGINNING INSTALLATION. POSITIONING AND ASSEMBLY OF ELEMENTS If the unit is installed in a place where there are corrosive substances (chlorine, etc. ) it is advisable to go over all the stainless-steel surfaces with a cloth moistened with paraffin oil in order to form a 8 The connection cable must be of the flameproof type with min. Water connection Water inlet Wash range hoods must be connected to the automatic wash programming and control panel (accessory not supplied) by means of a 3/4 pipe. By means of programming, the panel manages the automatic cycle for washing the filters located inside the hood. For panel installation, use and maintenance, comply with the instructions given in the special manual supplied with the accessory. Water drain The water drain is located at the bottom of the filtering zone, and must be connected to a floor drain by means of a 1 1/2" pipe. Earth connection Connect the various units to an efficient earth and include them in an equipotential system. € Start the hood and the complementary devices. € Check the efficiency of the system according to the various required specifications (electrical input, air flow, efficiency of wash system, light operation check, etc. € Train the user so that he becomes familiar with the command and control devices. The Manufacturer declines any liability if the safety regulations are not respected. € Wear protective gloves when carrying out equipment cleaning and maintenance operations. Caution: Do not wash the equipment with direct or high pressure jets of water. Idle periods During long appliance idle periods, take the following precautions: - unplug the appliance; - go over all the stainless-steel surfaces vigorously with a cloth moistened with paraffin oil in order to form a protective film; - periodically air the room. - Have the equipment completely checked periodically (at least once a year). For that purpose, it is advisable to stipulate a servicing contract. [. . . ] € Clean the stainless-steel surfaces with lukewarm soapy water, then rinse and dry thoroughly. important: Do not use products containing corrosive substances (chlorine bleach , hydrochloric acid , etc. ), even if diluted, or shavings, scouring pads, common steel brushes or scrapers to clean the steel surfaces. € Clean the ducts connecting the hood to the outside flue at least twice a year. [. . . ]