User manual WHIRLPOOL AGS 646/WP INSTRUCTION FOR USE

[. . . ] ELECTRIC OVEN AGS 646/WP Installation, user and maintenance instruction Instruction AGS 646-WP- rev9 english ed. 05 Page 1 di 15 CONTENTS SCHEMATIC REPRESENTATION GENERAL INFORMATION AND SAFETY INSTRUCTIONS General safety instructions Appliance specifications Legal requirements, technical regulations and directives Special conditions required for the place of installation Technical data Design characteristics POSITIONING, INSTALLATION AND MAINTENANCE Positioning 2002/96/EC (WEEE) directive Installation Electrical connection and equipotential bonding Commissioning test and putting into service Maintenance of the appliance USING AND CLEANING THE APPLIANCE User information and safety instructions USER INSTRUCTIONS Control panel Switching on Setting and using the timer Setting the temperature Interior light Cooking Care and cleaning of the appliance PRECAUTIONS IF NOT USING FOR LONG PERIODS PRECAUTIONS IN THE EVENT OF A MALFUNCTION RESERVED FOR TECHNICAL SUPPORT Wiring diagram Service connections Thermocouple connections Power connections Test mode and thermocouple configuration Control panel Pag. pag. 3 3 3 4 4 4 4 5 5 5 5 6 6 7 7 7 7 8 8 8 8 9 9 10 10 11 11 12 12 12 12 13 13 14 Instruction AGS 646-WP- rev9 english ed. 05 Page 2 di 15 SCHEMATIC REPRESENTATION GENERAL INFORMATION AND SAFETY INSTRUCTIONS GENERAL SAFETY INSTRUCTIONS - Carefully read the safety instructions in this booklet, as they will give you important information about how to install, maintain, and use the appliance safely. - These appliances are intended for professional use in a restaurant environment, and must therefore be used only by trained staff. - When in operation, the appliance should not be left unsupervised. [. . . ] - Certain functional faults can be due to user error, and it is therefore very important that staff should be correctly trained. - All installation and maintenance work must be carried out by a company duly entered on the company register. - Keep to the maintenance intervals recommended with the appointed technical support company. Page 7 di 15 Instruction AGS 646-WP- rev9 english ed. 05 - In the event of a malfunction in the appliance, disconnect all power supplies and call technical support. If a fault occurs repeatedly, technical support must be called. USER INSTRUCTIONS Before switching on and using the appliance for the first time, it is essential to carefully clean the oven interior and any accessories that come into contact with food. The set time can even be changed during the countdown, without stopping the timer. SETTING THE TEMPERATURE (fig. 2) - Switch on the oven (see paragraph “Switching on”). - Two different temperatures can be set: one of the upper zone and one for the lower zone, from 0 °C (heating element off) up to 450 °C. - Use the buttons (7) to set the temperature in the upper zone; the temperature is then indicated on display (10). Use buttons (8) to set the temperature in the lower zone; the temperature is then indicated on display (11). - Three seconds after the temperatures have been set, the display changes automatically from “temperature set” to “current temperature inside the oven”. - The set temperature can be displayed again for 3 seconds by pressing one of the buttons (+ or -) once. - If buttons + and - of (8) or (9) are pressed simultaneously for 3 seconds, the corresponding heating element is switched off and the word OFF appears on the display. The fans continue to operate, even though both heating elements are off. To bring the heating elements on again, simply press one of the buttons + or –. The heating elements can be switched on/off while the oven is in operation or when it is switched off. - To interrupt operation, press the switch (1). - When the oven is in operation, a third fan comes on to cool the internal components. Along with the interior fans, this fan remains on for 30 minutes, even after switching OFF; after this period, the fans are switched off automatically. To ensure long life for all the internal components in the appliance, it is essential, after using the oven, to wait for about 30 minutes before shutting off power at the main switch upstream of the appliance. 2) - Switch on the oven (see paragraph “Switching on”). - To switch on the interior light, press button (12). Instruction AGS 646-WP- rev9 english ed. 05 Page 9 di 15 COOKING Pizza: - Insert the cooking cylinders before switching the oven on. - When the oven reaches the set temperature, (400°C-420°C down and 380°C-400°C up), the oven is ready for cooking. Working temperature is reached in about 4 minutes. [. . . ] 2) - for the lower zone temperature (SW4) to light up the three lower parts of the lower zone temperature display. 2) + for the timer (SW5) to light up the three upper parts of the timer display. 2) - for the timer (SW6) to light up the three lower parts of the timer display. 2) for the timer (SW10) to light up the three centre parts of the timer display. [. . . ]