User manual WHIRLPOOL AKB 085 WH INSTRUCTION FOR USE

[. . . ] Packaging Packaging materials are 100% recyclable and are marked with the recycling symbol . Dispose of packaging materials in compliance with local waste disposal regulations. Packaging materials can be dangerous for children. Keep packaging materials (plastic bags, polystyrene, etc. ) well out of their reach. [. . . ] Make sure the lamps are cold before touching them. The hood is not a shelf, therefore do not overload or place objects on it. Do not use or leave the hood without its lamps correctly installed - risk of electric shock. Wear work gloves for all installation and maintenance operations. The product is not suitable for outdoor use. The air sucked by the hood must not be eliminated through the same flue of the heating system or other appliances using gas or other fuels. Note: always wear work gloves for all installation and maintenance operations. Declaration of conformity This product has been designed, manufactured and sold in compliance with the following standards: - safety objectives of the “Low Voltage” Directive 2006/95/EC (which replaces 73/23/EEC as amended) - protection requirements of “EMC” Directive 89/336/EEC amended by Directive 93/68/EEC. USING THE HOOD Switch on the hood a few minutes before starting to cook and leave it running for at least 5 minutes after you have finished. Pull out the steam drawer (depending on model). Turn the speed selector to the required speed setting according to the quantity of fumes and steam to be extracted. Switch off the hood 5 minutes after you have finished cooking. Close the steam-collecting drawer (where fitted). - 45 CARE AND MAINTENANCE Always disconnect the hood before cleaning or carrying out maintenance by unplugging it or switching off the power supply. The sponge grease filter should be washed in hot soapy water once a month (soak for 1-2 hours, do not wring, leave to dry and then remount. Replace with a new filter every 5-6 washes). • The grease filter paper should be replaced at least once a month. • Grease filter paper with saturation indicator should be replaced at least every two months or whenever the colour becomes visible through the holes of the grille. The paper filter is coloured on one side. This colour should not be visible through the grille holes when the filter is installed. • Metal grease filters should be washed once a month either by hand or in a dishwasher at a low temperature and in a short cycle. Leave filter to dry before remounting it. Washing in a dishwasher can cause grease filters to turn white, but this in no way affects efficiency. [. . . ] Filter Hood ( - see also installation sheet) Check that the switch inside the hood (if fitted) is on position “A” Extractor; if not, set it to this position. F Air is filtered through a carbon filter and returned to the room. The filtered air is released towards the kitchen ceiling. Warning!If the hood does not have a carbon filter, order one and fit it before use. Check that the switch inside the hood (if fitted) is on position “F” Filter; if not, set it to this position. If the plug is provided, close off the upper exhaust hole. Electrical connections Before connecting the hood, make sure the voltage indicated on the rating plate corresponds to the voltage in your home. [. . . ]