User manual WHIRLPOOL AKL 359/NE/02 PROGRAM CHART

[. . . ] • Clean the hob, when it is cool, after each use. This will prevent the build-up of dirt and make cleaning easier. • Use a clean cloth, absorbent kitchen wipes and washing up liquid or a specific glass ceramic cleaner. • Remove baked-on dirt with the special scraper tool (if provided) and specific cleaning products. [. . . ] • Always keep a watch on pans when cooking with oil and grease. The oil and grease might overheat and catch fire!• Do not use the hob as a support or worktop. • Do not leave the hot plates/cookers turned on when they are empty. TROUBLESHOOTING GUIDE The hob does not work: To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation. AFTER SALES SERVICE Before you call the After Sales Service • Make sure that you cannot solve the problem yourself following the points described in chapter “Troubleshooting Guide“. If after the above checks the fault still occurs, get in touch with the nearest After Sales Service. Please give: • a short description of the fault; • the exact type and model of hob; • service number (i. e. , the number that follows the word SERVICE on the rating plate under the hob itself). The service number is also indicated on the guarantee booklet; • your full address; • your telephone number. If any repairs are required, please contact an authorised After Sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). Failure to comply with these instructions may compromise the safety and quality of the product. Declaration of conformity • This hob is suitable for contact with foodstuffs, and complies with EEC Directive 89/109. • This hob (Class Y) has been designed to be used only for cooking. Any other use (such as heating a room) is improper and dangerous. • This hob has been designed, constructed and marketed in compliance with: - safety requirements of EEC Directive “Low voltage” 73/23; - protection requirements of EEC Directive “EMC” 89/336; - requirements of EEC Directive 93/68. The Manufacturer reserves the right to change product specifications without prior notice. INSTALLATION Recommendations Important: Disconnect the hob from the mains before carrying out any installation work or servicing. • All electrical connections must be made before connecting the appliance to the power supply. • Installation must be carried out by a qualified technician in accordance with the manufacturer's instructions and in compliance with local regulations. • Unpack the hob and make sure that the appliance has not been damaged during transport. If you are not sure contact the dealer or the nearest service centre. • If the worktop is made of wood, use the spring clips and screws provided. 1) as shown, paying attention to the specified distances. [. . . ] 70 mm of the cable sheath from the power supply cable (G). Insert the cable (G) through the opening in the lid (F). Important: remove any protective film before installing • Insert the cable into the cable clamp and connect the the hob. conductors to the terminal block as indicated in the Make sure that that the opening in the worktop for the hob is diagram printed on the lid. [. . . ]