User manual WHIRLPOOL AKL 702 NE PROGRAM CHART

[. . . ] • Position the cooktop into the prepared worktop. • Position the 3 brackets (C) as shown in the figure, in accordance with the thickness of the worktop. • Secure the three screws (E) in the holes (D). 83 5gb61301. fm Page 84 Wednesday, December 10, 2003 10:10 AM ELECTRICAL CONNECTION Electrical connection must be made before connecting the appliance to the electricity supply. The appliance must be installed by a qualified technician who is fully aware of current safety and installation regulations. [. . . ] The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the above regulations. For the electrical connection use a HO5 RR-F type cable as indicated in the table below: Power supply voltage. Conductors Amount x size 230 V ~ 230 V 3 + ~ ~ ~ ~ ~ 3 X 2. 5 mm2 4 X 1. 5 mm2 5 X 1. 5 mm2 4 X 1. 5 mm2 400 V 3N + ~ 400 V 2N + ~ The appliance must be connected to the electricity supply by means of an all-pole disconnect switch with minimum contact gap of 3 mm. Warning: the power supply cable must be long enough to allow the cooktop to be removed from the worktop and must be positioned so as to avoid damage or overheating caused by contact with the base. Terminal block connections Note: the yellow/green earth wire must be connected to the terminal with the symbol and must be longer than the other wires. 70 mm of sheath from the power supply cable (B). Then insert the power supply cable into the cable clamp and connect the wires to the terminal block as indicated in the diagram located near the terminal block. • Secure the power supply cable (B) by means of the cable clamp. • Close the terminal block cover (A) and tighten its screw. • After the electrical connection, fit the hob from the top and hook it to the support springs, according to the illustration. 84 5gb61301. fm Page 85 Wednesday, December 10, 2003 10:10 AM ENERGY SAVING TIPS • Use pots and pans whose bottom diameter is equal to that of the cooking zone. • Only use flat-bottomed pots and pans. • If possible, keep the pot covered when cooking. Do not place food wrapped in aluminium foil, plastic containers or cloths on the hot cooking zones. Do not drag pans across the glass-ceramic surface - risk of scratches. Avoid spilling sugar and similar substances on the cooktop. If necessary, clean the cooktop immediately following the care and maintenance instructions in this handbook. If you have a cooktop with halogen cooking zones, avoid looking straight at the lamps. COOKTOP ACCESSORIES Child guard accessory AMH 122 This accessory can be obtained from the After-Sales Service under Part N° 4819 310 18436. 86 5gb61301. fm Page 87 Wednesday, December 10, 2003 10:10 AM CARE AND MAINTENANCE OF THE GLASSCERAMIC COOKTOP Clean the cooktop, when it is cool, after each use. This will prevent the build-up of dirt and make cleaning easier. • Use a clean cloth, absorbent kitchen wipes and washing up liquid or a specific glass-ceramic hob cleaner. • Remove baked-on dirt with the supplied scraper tool and specific cleaning products. • Food spills should be cleaned off before they bake onto the glass-ceramic surface. • Foods with a high sugar content (toffee, fruit syrup, jam, etc. ) that boil over onto the hob or sugar spills must be removed immediately using a scraper. • Do not use abrasive products, bleach, oven-cleaner spray or pan scourers. [. . . ] Did you dry the hob carefully after cleaning it? • • 1. If a cooking zone has been selected and an “F” appears on the display, contact the After Sales Service and inform them. If the cooktop does not work following intensive use, the cooktop internal temperature is too high. Wait a few minutes until the cooktop cools down. [. . . ]