User manual WHIRLPOOL AKL 831/NE PROGRAM CHART

[. . . ] Do not use multiple plug adapters or extension leads. After the oven has been installed, the electrical components must be inaccessible. Make sure that the voltage shown on the rating plate is the same as the power supply voltage in your home. Remove the cardboard protections and the protective plastic film. [. . . ] The oven must be repaired or adjusted exclusively by a qualified technician. Make sure that the electrical wires of other electrical appliances near the oven do not come into contact with hot parts and do not become entrapped in the oven door. Use oven gloves to remove baking trays and accessories when the oven is hot. Do not cover the bottom of the oven with aluminium foil. Do not place inflammable material in the oven - risk of fire if the oven is inadvertently switches on. The oven is equipped with air cooling system to prevent excessive temperatures of the oven front and furniture housing. Following cooking times greater than one hour at temperatures of 200° C or more, it is recommended that residual heat from the oven and housing be removed by use of a cool down period. At completion of cooking, leave the oven on, in any cooking function but grill with the “temperature knob” on “0” position, for about 15 minutes. The oven door must remain closed during the cool down period. • During the cooking process, water evaporates from food. All ovens require this steam and other fumes to be vented from the oven cavity. Wash the accessories in a dishwasher or in the sink, using an oven cleaner. After the oven has been in prolonged use and when cooking on different levels (especially food with high water contents such as pizzas, stuffed vegetables, etc. . . ) condensation may form on the inside of the door seal. Lift the catches until they engage and then remove the door. Warning: While you are cleaning the oven, ensure you do not disengage the hinge retainer catches. Refit the oven door by following the above steps in reverse order. Dropping the grill element to clean the oven roof (depending on model) • Do not attempt to clean the oven until it is cool. To clean the oven roof, pull out the grill element and lower it as far as it will go. Clean the oven roof and then return the grill element to its original position. Disconnect the oven from electrical supply. Changing the lateral lamp (depending on model) Disconnect the oven from electrical supply. Use a screwdriver to prize off the lamp cover. [. . . ] • Oven selector on position “0” • Check whether you have made the temperature setting and the function setting. • If the electronic programmer display (depending on model) presents the message “OFF”, press any key to reset the oven and then set the clock. Try to solve the problem (see “Troubleshooting Guide”). Turn off the appliance and restart it to see if the fault is repeated. [. . . ]