User manual WHIRLPOOL AKM 176/WH INSTRUCTION FOR USE

[. . . ] • In case of prolonged use, additional ventilation may be needed (opening a window or increasing the extraction force of the hood). • Keep children away from the cooking hob when it is in use. • After use, ensure that the knobs are in position (off), and close the main gas delivery valve or the gas cylinder valve. • Caution: the lid (where present) might break if overheated. [. . . ] The burner fails to ignite: • Is the main gas delivery valve open?• Has the delivery of the town gas (methane) been suspended?• Is the gas cylinder (liquid gas) empty?• Are the openings of the burner clogged?• Have the cap and burner been positioned correctly after cleaning?(See paragraph “Care and maintenance”. ) 2. The burner fails to remain lit: • Repeat the ignition operation, turning the knob to the position with the small flame symbol . The electric ignition device does not work: • Is there a power failure? AFTER SALES SERVICE Before you call the After-Sales Service: 1. Check the “Troubleshooting guide” above to see if you can eliminate the trouble yourself. Re-start the cooking hob, to check whether correct operation has been restored. If the malfunction persists, call the After-sales Service. Give the following information: • type of malfunction; • model of cooking hob; • service number (i. e. , the number that follows the word SERVICE on the rating plate under the cooking hob and on the guarantee paper); • your complete address; • your telephone number and area code. If any repairs are required, please contact an authorised After-Sales Service, as indicated in the warranty. In the unlikely event that an operation or repair is carried out by an unauthorised technician, always request a certification of the job carried out and insist on the use of original spare parts. Failure to comply with these instructions may compromise the safety and quality of the product. 14 3gb66001. fm5 Page 15 Monday, November 12, 2001 3:00 PM INSTALLATION Technical information for installer This cooking hob can be embedded in a worktop 20 to 50 mm thick. If there is no oven beneath the cooktop (any oven installed must be manufactured by us and equipped with a cooling system), insert a separator panel at a minimum distance of 20 mm from the bottom of the cooktop. Note: before installation, make sure that the local gas delivery conditions (nature and pressure of gas) are compatible with the settings of the cooking hob, as indicated on the rating plate. • If a vertical piece of furniture is installed, there must be a gap of at least 100 mm between it and the edge of the cooking hob. [. . . ] Note: when liquid petroleum gas is used (G 30/G 31), the minimum gas setting screws must be tightened as far as they will go. Replacing the injectors (see table in enclosed product description sheet) 1. Using a socket spanner of the appropriate size, “C”, unscrew the injector to be replaced. Replace it with the injector suitable for the new type of gas. Re-assemble the injector in “D”. [. . . ]