User manual WHIRLPOOL AKM 212/NA/01 INSTRUCTION FOR USE

[. . . ] • Caution: the lid (where present) might break if overheated. Before closing it, make sure that all the burners are off. • Warning: The protective rubber feet on the panstand grids represent a choking hazard for young children. After cleaning the panstand grids, please ensure that all the rubber feet are correctly fitted. [. . . ] Note: to avoid damaging the electric ignition device, do not use it when the burners are not in their housing. Cleaning the electric hotplate The electric hotplate must be cleaned when it is lukewarm. Wipe with a cloth moistened with water and salt, and polish with a cloth moistened with oil. 13 6gb61801b. fm5 Page 14 Friday, April 11, 2003 2:44 PM TROUBLESHOOTING GUIDE 1. The burner fails to ignite: • Is the main gas delivery valve open?• Has the delivery of the town gas (methane) been suspended?• Is the gas cylinder (liquid gas) empty?• Are the openings of the burner clogged?• Have the cap and burner been positioned correctly after cleaning?(See paragraph “Care and maintenance”. ) 2. The burner fails to remain lit: • Repeat the ignition operation, turning the knob to the position with the small flame symbol . The electric ignition device does not work: • Is there a power failure? AFTER SALES SERVICE Before you call the After Sales Service: 1. Make an opening in the worktop, according to the dimensions indicated in the enclosed Product Description Sheet. B) If the worktop is made out of marble or other materials (plastics, ceramics or stone), fix the hob by means of brackets (A) (see figure on previous page), to be ordered from the After Sales Service (code 4819 310 18528). Electrical and mechanical connection • The electrical connections must comply with local regulations. • The data relevant to the voltage and power absorption are indicated on the rating plate. • The earthing of this appliance is compulsory by law. • The manufacturer cannot be held responsible for any injury to persons or animals or damage to property arising from failure to comply with these requirements. • When the cooktop is installed, provide a single-pole circuit breaker with a contact separation of at least 3 mm. Connection to gas supply The gas supply system must comply with local regulations. You can find specific local regulations for some countries, in the separate National Safety Regulations Sheet supplied. If no information concerning your Country is given, please ask details to your Installer. The connection of the cooktop to the gas pipe network or gas cylinder must be made by means of a rigid copper or steel pipe with fittings complying with local regulations, or by means of a continuous-surface stainless steel hose complying with local regulations. Interpose gasket “B” in the elbow connection “A”. ONLY FOR BELGIUM: It is necessary to replace the elbow connection (A) on the appliance, with the one supplied. [. . . ] Use pressure regulators suitable for the gas pressures indicated in the separate Product Description Sheet. The gas nozzles must be changed by After Sales Service or a qualified technician. Nozzles not supplied with the appliance must be ordered from After Sales Service. Connect the cooktop to the gas shut-off valve by means of a pipe suitable for the type of gas used, in compliance with current local regulations. [. . . ]