User manual WHIRLPOOL AKM 260/JA PROGRAM CHART

[. . . ] If you select “Rinse Hold” do not leave items to soak for too long. A very gentle spin is used in this programme. — — — — Same as the last rinse and the final spin in the “Coloured Cotton” programme. [. . . ] Same as the spin cycle in the “Coloured Cotton” programme. Same as the spin cycle in the “Wool” programme. Alternative method of terminating programme after “Rinse Hold”. Softener Main Wash E Detergents and additives Prewash Prewash Special options Intensive Rinse Rinse Hold Spin Speed Reduction Programme Type of wash / Notes Max Spin Speed rpm Temperature °C 5. 0 5. 0 2. 5 3. 0 1. 5 1. 0 1. 0 5. 0 5. 0 1. 5 — ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ — — — Yes Yes Yes Yes Yes Yes Yes — — — — ❉ ❉ ❉ — ❉ ❉ ❉ — ❉ ❉ ❉ ❉ — — ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ — — — ❉ ❉ ❉ 1) ❉ ❉ 1) ❉ 1) ❉ 2) ❉ ❉ ❉ 1) — 1200 20 to 95 20 to 60 20 to 60 20 to 60 20 to 40 20 to 40 20 to 30 — — — — 1200 800 1) Rapid Plus Delicates Wool 1200 800 1) 800 1) ❉ — — — — — — ❉ — Handwash + Rinse + spin Spin Gentle spin Drain — — — — — — 400 2) 1200 1200 800 1) ❉ — — — — Whirlpool is a registered trademark of Whirlpool USA. 5019 301 05080 CONSUMPTION DATA Programme White Cotton Coloured cotton Coloured cotton Synthetics Synthetics Rapid Plus Delicates Wool Silk Temperature Selector (°C) 95 60 40 60 40 30 30 40 30 Load (kg) 5. 0 5. 0 5. 0 2. 5 2. 5 3. 0 1. 5 1. 0 1. 0 Water (l) 49** 44 44 55 50 37 50 55 37 Energy (kWh) 1. 70 0. 95 0. 55 0. 80 0. 60 0. 40 0. 50 0. 50 0. 40 Approx. Programme Duration (hours : minutes)* 1:50 2:00 1:50 1:25 1:20 0:30 0:45 0:40 0:40 Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with Standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. **To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. Terminate the “Rinse Hold” option: • Press the “Rinse Hold” button again; the programme will terminate automatically with the final spin cycle for the present wash programme. Do not add detergent for this programme. Press the “Start/Pause” button to pause the programme. Set the programme selector to “Drain”. The spin indicators show “0” and the remaining time shows “0:02”. Press the “Start/Pause” button to start the drain programme. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add the detergents as described in the programme table or in the chapter “Detergents and Additives” in the booklet. Turn the programme selector knob to the desired programme. The remaining time display shows the duration of the chosen programme (in hours and minutes) and the pilot lamp of the “Start/Pause” button is flashing. The programme sequence and the predefined spin speed indication corresponding to the selected programme lights up. The recommended temperature (see the indicator) can be altered by pressing “+” or “-” button. [. . . ] The recommended temperature (see the indicator) can be altered by pressing “+” or “-” button. SELECT ANY DESIDERED OPTION Selecting any option the indication lights up. When the combination of programme, additional options and temperature is not possible, the indication lights switch off automatically. [. . . ]