User manual WHIRLPOOL AKM 330/AR PROGRAM CHART

[. . . ] • In case of prolonged use, additional ventilation may be needed (opening a window or increasing the extraction force of the hood). • Keep children away from the cooking hob when it is in use. • After use, ensure that the knobs are in position (off), and close the main gas delivery valve or the gas cylinder valve. • Attention: the lid (where present) might break if overheated. [. . . ] • Do not use abrasive or corrosive products, chlorine products or steel wool. • Do not use vapour cleaning appliances. • Do not leave acid or alkaline substances, such as vinegar, salt or lemon juice, etc. , on the cooktop. Stainless steel surface • Clean it with a specific commercial product. Note: if the cooktop is used continuously, the high temperatures produced by the flames may alter the colour of the surface near the burners. Cleaning the cooktop surface, panstand grids and control panel Cleaning the burners 1. Extract the burner from its housing by pulling it up. Soak the burner and the cap in hot water and liquid detergent. Ensure that none of its openings is clogged. Note: to avoid damaging the electric ignition device, do not use it when the burners are not in their housing. 15 TROUBLESHOOTING GUIDE 1. The burner fails to ignite • Is the main gas delivery valve open?• Has the delivery of the town gas (methane) been suspended?The outer surfaces of the furniture or appliances adjacent to the cooktop must be heat resistant (T 90°C). • Installation must comply with current local regulations. • In the room where the cooktop is installed, there must be enough air to allow the gas to burn correctly (see the separate Product Description Sheet). • Continuous natural air circulation is ensured through an opening in a wall. This wall opening must be: - permanent and in a wall to the outside of the room to be vented, situated far from sources of pollution; - made in such a way that it cannot be obstructed from the inside or outside (not even accidentally); - protected by grids, metal nets, etc. , taking care not to reduce the air vent effective area mentioned above; - located near floor level and positioned so as not to interfere with the operation of the exhaust system. - Combustion products must be discharged outdoors through specific hoods or wall and/or window mounted electrical fans. Fig. 3 17 INSTALLATION Electrical connection • The electrical connections must comply with local regulations. • The data relevant to the voltage and power absorption are indicated on the rating plate. • The earthing of this appliance is compulsory by law. • The manufacturer cannot be held responsible for any injury to persons or animals or damage to property arising from failure to comply with these requirements. • When the cooktop is installed, provide a single-pole circuit breaker with a contact separation of at least 3 mm. [. . . ] Attention: Should you experience difficulty in turning the burners knobs, please contact the After Sales Service for the replacement of the burner tap. 18 INSTALLATION ADJUSTMENT TO DIFFERENT TYPES OF GAS If a different type of gas from the one indicated in the plate is used, the cooktop must be adapted to it. Use pressure regulators suitable for the gas pressures indicated in the separate Product Description Sheet. The gas nozzles must be changed by After Sales Service or a qualified technician. Nozzles not supplied with the appliance must be ordered from After Sales Service. [. . . ]